Your cart is empty.
Your cart is empty.Product Description
Hillman 370824 Hex Head Sleeve Anchor, 1/4 X 2-1/4-Inch, 40-Pack
From the Manufacturer
Concrete Sleeve Anchors' design allows them to anchor into concrete, brick and block. Turning the nut pulls the working end of the sleeve anchor up through the sleeve, expanding and anchoring itself securely in the concrete, brick or block.
Sterling H Thomas
August 28, 2025
Worked as described and expected.
ERP
July 26, 2025
Used these on my walkway solar lights because the 3M putty tape was just falling off from the brick. These Anchors are great and you can actually cut them to the exact length needed they are a good product
Tom Pittlik
July 10, 2025
I had to secure many things into circa 1900 brick, which is much softer than modern brick and mortar. Tapcon blue screws and other anchors are not suitable for these bricks. These anchors work great. I use a pipe brush after drilling to remove dust from the hole. I also use the non-hammer setting to avoid cracking the brick - to do this you will need a glass of water to regularly cool the bit down.
Donald g Wright
June 24, 2025
Does the job.
freedomdriven
June 11, 2025
They really worked as expected. I have an old house and behind my drywall is brick and the hex bolt penetrated the brick enough to secure my TV to the wall
Dan Casement
June 6, 2025
Appeared to be good quality, the 3rd bolt snapped off as it was snugging itself down, using a small open ended wrench and maybe 10lbs force. Too bad. The 3 after this didn’t snap but I didn’t take them too snug either.
Lone Star Legend
May 29, 2025
The SLEEVE is 1/4†not the bolt. The bolt is smaller and is more like 3/16â€. The bolt size should be available too. Had to return it.
DR. PHIL HARMONIK
May 21, 2025
EZ to install ! Very good product and highly recommended
Binky Inky
January 22, 2025
the one thing I was a little hesitant if it was 40 full sets or 40 pieces, like 10 washer, 10 screws, 10 sleeves and 10 nuts, But it was 40 full sets, a great deal
Recommended Products