Your cart is empty.
Your cart is empty.Product Description
A push nut has no threading but has an inward facing flange. The flange is meant for quick assembly as no tools are needed, the nut can be pushed into place. This is meant to be a permanent application unless specific tools are obtained to cut them off.
From the Manufacturer
A push nut has no threading but has an inward facing flange. The flange is meant for quick assembly as no tools are needed, the nut can be pushed into place. This is meant to be a permanent application unless specific tools are obtained to cut them off.
George Asan
2025-08-27 17:28:00
Haven't used them yet as I expect them to do the job as advertised
Drew
2025-08-04 12:17:04
These can be tapped into place quite easily, but I dare you to pull one off after its been installed! I doubt you can because the grip the axle's end so tightly. This is much faster and easier than drilling a hole and installing a cotter key.
Erick Hays
2025-07-31 13:20:32
Excellent product to fix our rolling Igloo cooler wheel
Vincent Immiti
2025-07-23 14:49:45
Turned a non rolling cooler into a rolling cooler again!
V J TROST
2025-07-12 13:26:54
I used this rod cap on the axle for a garbage can. I had to replace the wheels and upgraded to a thicker axle shaft. I was able to fully set this with a deadblow hammer. It has stayed in place and is still shiny several years later. I would buy this again if I needed additional caps.
Joe
2025-04-24 11:47:42
I but it to replace a Push-On Pushnut on my pellet stove and it does the job better then the original part. And it was easier to install as well.
Harry Norman
2025-02-14 10:44:23
Didn’t know actual size of metal rod so ordered 3 different sizes . Worth it due to prices
Customer
2024-12-25 14:16:55
As described. First class mail isn't the quickest shipping as a Prime member.
Recommended Products
