Your cart is empty.
Your cart is empty.Product Description
Flysky FS-BS6 Receiver with Gyro Stabilization System for FLYSKY RC IT4S/GT5 Radio Transmitter Remote Controller for Rc Car, Rc Truck, Rc Boat
Flsyky rc bs6 receiver overview
6 channels rc car receiver for flysky GT5 / IT4 radio controller remote controller
Led Status Indicator
It is used to indicate the power and working status of the receiver
Off: The power is not connected
Lit in red: The receiver is on and working
Flashing quickly: The receiver is binding
Flashing slowly: The bound transmitter is off or signal is lost.
Connectors
Used to connect to the model and servos
Built in gyroscope SVC function that can be used to improve handling.
Gyro Calibration for Flysky Rc BS6 Receiver for GT5 Radio Controller Remote Controller
Gyroscope Calibration
The gyro has been calibrated at the factory however if it needs to be recalibrated, follow the steps below:
1. Turn off the transmitter and insert power into channel 1 (not the bind port)
The receiver's LED should start to flash slowly
2. Place the receiver on a flat horizontal surface, make sure it cannot move.
3. Insert the bind cable (plug) into the bind port. The receiver's LED should start to flash rapidly 3 times then return to the previous flash speed if the calibration has been done successfully
Servos connection to FLYSKY RC BS6 Receiver
Note: to ensure the gyro works as expected, install the receiver horizontally at less than 10 degrees from level on your vehicles
Bind FLYSKY BS6 Receiver to FLY SKY GT5 Remote Controller or Compatible Model or Brand
Binding
Please follow the steps below to bind the BS6 receiver to your remote controller
1. Connect the bind plug to the receiver's port B/VCC
2. Connect power to any other port on the receiver
3. Press and hold the transmitter bind key and turn on the transmitter in the same time.
4. Once binding is complete, the transmitter will exit bind mode. Remove the power and bind plug from receiver, then apply power to the port B/VCC
5. Check to make sure everything functions as expected, if not, please repeat the steps above.
Note, if you are quite sure you follow the above steps completely correctly, please consider to update the firmware of your radio controller or receiver. And if you are still having problem, please check and make sure the receiver IS compatible with the brand and model of your transmitter.
Johanna
2025-07-26 11:29:30
Works just fine. Easy to bind
Francisco AC
2025-07-07 14:57:08
Excelente
Timothy sanborn
2025-07-04 15:22:47
These are perfect and quality rx for your flysky fsgt5
Juan
2025-06-11 14:25:36
Works perfectly with my Flyskygt5
Derrick Sarosi
2025-02-28 17:08:11
Sounded like a great deal. Steering and throttle channels are backwards. Channel 1 should be esc but instead it’s steering. Channel 2 is esc.I bought 3 of these receivers and all 3 do not function. Steering lags tremendously, does not recenter AND requires a full system reset followed by having to rebind all 3.Skip this product and buy something that works. When it looks to good to be true it’s because it is.I removed all 3 receivers and put back to stock setup. Runs perfect!
Josue Perales
2025-01-20 15:32:47
Vary good receiver
Recommended Products