Shopping Cart

Your cart is empty.

Your cart is empty.

HobbyPark 20pcs 1.3mm Adjustable Pushrod Connector Linkage Stopper & Φ1.2mm x L180mm Steel Z Style Pushrods Parts for RC Airplane Plane Boat Replacement

Free shipping on orders over $29.99

$9.97

$ 4 .99 $4.99

In Stock
  • Package Include: 10x Pushrod Connector Linkage Stopper + 10x Pushrods + 1x Hex Wrench, 20pcs In Total
  • Z Push Rods Size: Φ1.2mm x L180mm
  • Pushrod Connector Size:Diameter of the Hole:1.3mm, Compatible with 1.0 / 1.1 / 1.2 / 1.3mm Pushrods
  • Application:RC Airplane Plane Boat etc.


Note:The color of the item may vary slightly due to photography and your own computer /Phone
Please allow some little manual measurement error.
Customer Satisfaction Guarantee
If you are not completely satisfied with our products, please do not hesitate to contact us to request a refund or exchange!
Note:Check your specific model's manual for compatibility,or Contact us.


Mic Sherwood
2025-08-30 18:46:10
these 1.6mm parts are so hard to find. this kit is a must have, in every build.
Seckhala
2025-08-25 19:34:08
I fly RC gliders. I have had some spectacular crashes: the whole plane has been turned to powder...ecxept these rods and adapters. They will rip the wing servo out of the wing! You can't break these things! You can't bend or flex the control rods. Strongest rods at this weight that I have ever used. I have comlete faith that these rods and adapters willl stand up to any abuse you can put them through. This is a great product!
Paul B
2025-08-19 17:52:41
smaller size clamps and smaller diameter of wire than I expected, but it will no doubt work fine. The pre-bent end is appreciated as it is quite hard to get the bends right by hand.
Ryan Bratton
2025-07-11 16:51:11
Nice tight Z bends. Can hardly go wrong with this kit for the money. Will definitely buy again.
Henry Martinez
2025-06-18 09:26:48
This size is extremely small very thin wire for very small models tried to use for a 28-in boat rudder but was too small otherwise good quality well priced fast shipping
Dexter
2025-06-06 11:26:36
These adjustable linkages work great, come with the necessary hex wrench to tighten the screws, and seem to be pretty sturdy for your servo needs.
SammyB
2025-05-28 12:33:40
Perfect length for Eclipson or most any aileron linkage where the aileron servo is in the wing. Nice and straight and I like the hardware better than Dubro.
ped
2025-03-11 10:50:08
I didnt realize these are TINY little wires and connectors. They work but theyre going to deflect like crazy.
mike b.
2025-01-22 19:30:23
I don't like anything about this item very cheap