Hold It Mate fits ONLY Vertical Spindle Systems

The Building Code for railings across the US is fairly consistent with a 4" space between the spindles. Please measure before you order - Out of date wide spaced spindles will not work. Only up to 5" opening between will work, but anything built in the last 25-30 years is usually 4" or less.

Inserting the sleeve nut into the recessed hole

The Sleeve Nut is what will hold the carriage bolt, it is vital you insert this into the recessed side of the 6" mounting rails. Using the recessed side allows for accessory attachment over the nut, as well as allowing proper fitment of the bolts into the sleeve nut. This is the number 2 reason customers have installation issues - please insert the sleeve nut into the recessed side.

Bolt Options - Choose Properly

The Bolt that is the correct length for you will be equal to or just slightly longer that the width/thickness of your spindles.

• Wrought Iron 1/2" thick = Small Bolt
• Aluminum 3/4" thick = Small Bolt
• Vinyl, Trex Usually 1" - 1 1/4" = Medium Bolt
• Wood 1 1/4" to 1 3/4" = Long Bolt

Follow this guide direction closely, makes for easier attachment!

Just turn the bolts into the sleeve nuts enough to hold in place, this will allow easier connecting to the spindles.

Slide the newly connected bolt into the keyhole slot

Once connecting both shorter rails to the longer mounting rail, hold the long rail up level, while the smaller rails hang vertically - allowing you to insert the shorter rails through your spindles. Turning in the bolts at a minimum as mentioned in the last step, allows for space to turn the short mounting rails horizontal, if the bolts are in too far, you won't be able to turn the small mounting rails. Simply snug one side up enough for it to hold, not tight...then snug up the other side. Now ensure you a level using a level or your eye - using the top handrail as a level guide works well. Once level, snug up the bolts.

Hanging the short rails vertically

This allows the short mounting rails to pass through the spindle space. Once both sides are through, simply turn (one) small mounting rail horizontal and slightly tighten, just enough to hang onto the spindles...then turn the other small rail, both should straddle the spindles evenly - like the next picture shows. Make sure they are level and tighten, but not too much!

Never Over Tighten the Bolts

Using too long of a bolt will not allow the system to get snug with your spindles, use the next size down if this is the case. The main reason for issues is THIS! ^^ If the system is not tight to the spindles, it is always because too long of a bolt was used and the bolt ran out of tightening room in the sleeve nut.

Easily snap on and lift up to take off

Only Hold It Mate accessories will fit Hold It Mate mounting rails, they are patented and proprietary. Our products are all heavy duty and build for the task at hand.

We've written a lot here, as we want our customers to have a terrific experience with our heavy duty solution. 24 Hr Support via Amazon if you ever have any questions! But, its super easy and you'll love the versatility!