Your cart is empty.
Your cart is empty. Use bender can save time for fuel spillage and pouring into the tank
Fits
For LC2 Racing Utility Containers
Colton Bill
2025-07-19 13:15:30
If it kinks when you put it on the hose, try heating up the hose a little first to soften it up. Other than that it works great for the hose that comes with the can.
Jazzy
2025-07-17 11:12:07
Nice upgrade for 5 gallon gas can perfect angle for pouring.
Mark Logaglio
2025-05-17 15:56:04
They squeeze the tube plus where the shut off valve is it goes from a half inch to a quarter inchrestrict the gas flow and and a break up right where the screw in to the cap would not recommend buy
Alpha
2025-02-05 18:13:56
I bought others from a powersports shop that I like better. These do the job, but the plastic is noticeably stiffer and the bend is a sharper angle. To install, drop the bender in a cup of hot water for a few minutes to make the plastic slightly more pliable and heat the hose with a hair dryer. Then put it on the hose and work it up and down the hose to eliminate kinks.
Dale Courtney JR
2025-02-02 12:19:38
Good product and works great. Hard to put on a brand new tube was my only issue.
LoveShoppingOnline
2025-01-19 18:44:30
Works with h KTM glass can.
Susan Ramsay
2025-01-04 10:58:09
Does not work as described. Kinks the hose.
Jay Parmer
2024-12-12 11:53:46
It’s perfect, i did have to heat up the hose slightly because it was cold outside but it went right on.
Recommended Products
$38.78
$ 17 .99 $17.99