Your cart is empty.
Your cart is empty."The 1" HC Flow Meter detects, monitors, and reports critical flow zone data and total system flows. It is designed for use with Hydrawise enabled HC Wi-Fi irrigation controllers to maintain healthy landscapes and achieve maximum landscape protection. If abnormal flows are detected, Hydrawise will send an instant alert to check the system for maintenance needs before costly landscape damage occurs."
CA Guy
2025-08-14 15:21:21
Adding this flow meter dramatically increases the usefulness of the Hydrawise sprinkler management system. I dug up the area around our back flow preventer device and added this flowmeter downstream in a straight length of pipe. Requires straight pipe at least 10 inches upstream and 5 inches downstream of the flowmeter.The signal output flex conduit is relatively short, but by loosening the mounting screw I was easily able to rotate the meter display assembly to allow the flex conduit to exit directly towards my junction box. The thread on the end flex cable takes a M6-1.0 nut (from Home Depot) to mount into a hole in a junction box.
AC
2025-08-07 18:08:10
I purchased the 1†Hunter flow meter primarily to measure water usage on the lawn to determine correct water usage. I am using this meter with the HPC Hydrawise compatible face panel replacement with my old (2017) Pro-C controller. Many recommendations for watering a lawn are in gallons per square foot/week or inches per square foot/week (easily convertible to gallons). Irrigation controllers typically are time based. With this meter I can now get a good estimate of how much water is going onto the lawn and make adjustments accordingly.I installed this meter between the anti-siphon valves and the zone valves boxes. According to the installation instructions I left about 12†straight inline on the intake and exhaust sides. The instructions also recommend to remove or bypass and drain the meter if you live in a climate where you need to winterize. To do that I installed the meter with L union PVC fittings and built a replacement piece with compressor fitting for winter blowout (see image). The meter has a solid brass body so can imagine would not do very well if full of water and frozen. One other consideration is that this meter does have some drain on water pressure. According to the charts in the installation manual I can expect about 4psi drop using the 1†meter and 10 gallons/min draw (my maximum). With a starting pressure of 62psi that was not a problem for me.Initial tests comparing the utility water meter (in cu/foot) and this Hunter meter (gallons) show that they are fairly close. A much cheaper way to get water estimates is with a tin can and measuring stick. That works unless you have subsurface drip irrigation, but in any case not as much fun as measuring/controlling usage from your laptop/phone. So far I have been able to reduce lawn water usage in half using measurements from this meter. I was overwatering using the time based irrigation method. Using this meter and the Hydrawise app to adjust for weather and seasonal variations is working great.
Donald R Dietrich
2025-07-13 11:14:18
The flow meter was easy to install. I need it to show if my irrigation system has any leaks since the main meter to the house is fifty yards away and down a steep hill. Now I can quickly check for leaks after repairs. I have older Hunter irrigation controllers, so I could not connect the meter to them for automatic leak sensing.
Michael P.
2025-04-14 16:51:23
Just replaced my Hunter HC100 flow meter. First one installed January 2021, failed June 2023 (warranty is 2 years, but from the *manufacture* date, which was June 2020). The reed switch on my original unit failed open circuit. No response in two months from Hunter tech support regarding options, so just bought another. But! After several hours digging, pulling old unit, and installing new HC100, noticed there is a back-up reed switch, not documented in the manual but shown inside the lid diagram (which of course I could not see down in the hole.) So next failure, I’ll try connecting the back-up before the expense and effort of replacing the entire meter.The HC100 flow meter in conjunction with my Hunter ProHC-1200 controller lets me configure irrigation and then detect problems via the Web interface. Have found cracked risers (back when I could afford water for turf) and cracked pipes where neighbors turned too wide and ran over sprinkler heads. With my top water rate in Vegas $15/1000 gallons, tracking irrigation performance is very important.Regarding shipping, the HC100 was shipped via USPS in a plastic bag, resulting in a beat-up box. Meter seems OK. You would think with something heavy costing $150 they could afford to ship in a box?
Kindle Customer
2025-03-23 11:02:29
Great price and fast shipping
Alton
2025-02-11 20:16:39
I can now watch for broken lines and sprinkler heads. I added a dummy channel to the Hydrawise controller to know how much water I added to the pool.
Bobstar
2025-01-03 16:42:34
Works great, easy to install and now displays water totals for my lawn.
matt1mike1
2024-12-04 18:01:40
Great to track your water usage
Recommended Products
$210.75
$ 83 .99 $83.99