Your cart is empty.
Your cart is empty.GONE
2025-08-29 15:45:12
This product allows for different rims, offsets, and extended hex.. so you have enough threads to keep your tires on.They work well. They fit easy. They installed quickly.This product does exactly what it is supposed to do, for a fair price.
Gcj
2025-08-24 12:59:52
Definitely do what they're supposed to do
james cross
2025-08-17 19:09:19
Great fit for my trx4m bronco, well made ,definitely recommend
David M
2025-07-26 17:24:27
As I've started upgrading, adding wheel spacers and different rims, I found some combinations wouldn't work because the stock shafts don't have enough thread.They were a little tricky to get the pins installed to assemble the front CV joints but it wasn't too hard. I now have much more thread engagement and could use wider spacers if I wanted too.
Harsam4323
2025-07-12 17:43:59
Bought these to give a little extra for the hex nut to bolt into. I didn’t want to extend my wheel base too much but wanted bigger tires. This combined with larger brass sockets is perfect and don’t have to use the smaller hex but you can use the factory ones
Ed
2025-05-29 10:35:26
Once I had them installed they work very well, and I can get larger offset hexes on. BUT I didn't even use the straight section of these, they did not fit onto the Injora bearings I have. So I used the inner stock axles. I also had an issue where on one axle, the flat section where the large hub bearing sits was way too big. I ended up spinning the axle in my drill and sanding the outside with sandpaper. I eventually got it to fit nicely, but I couldn't use half of the product, and had to modify the remaining half to get it to fit.
Kelly
2025-05-25 17:11:49
Injora is the only parts i put under my TRAXXAS (get your injora today) 😎ðŸ‘
Huey
2025-04-28 13:14:27
Rear axles fit with no issues. Front axles were a different story. The axle shaft was too big for Traxxas bearings in the c-hubs but did fit with the stock bushing. The cv cup had a very tight tolerance with larger bearing in the knuckle. What should have been quick took a lot longer due to fitment issues.
Peter Porn
2025-03-30 14:41:34
Alles gut
Graham
2025-03-24 18:50:32
Fit my sons trx4m defender perfectly. Thread on axle is longer so you can run extended wheel hexes.
Customer
2025-03-14 10:20:20
Super well machined parts - fits perfect and the added length worked nicely to get nylock nuts on with Injora 6mm hexs.
christian
2025-02-20 17:22:16
Grundsätzlich super. Nur an den Wellen der Vorderachse musste ich minimal nacharbeiten dir das Kugellager drauf passt. Ansonsten wirklich gut.
Dragos B.
2025-02-13 09:59:19
Once I mounted all the pieces of the front CVD axles together, I found out that the joints bind and won't move freely not even if I try to loosen them by hand... I'm so disappointed with this product, as the stock CVD axles seem to move thousands of times smoother...Maybe they will give way in time, but in this state they can't be installed on my trx4m, so I guess I will return them...
Recommended Products
