Your cart is empty.
Your cart is empty.Item Condition: Brand New All necessary mounting hardwares, vacuum hoses and reducers will be included like shown in the picture. No additional parts will be needed for installation after you purchase this kit.
Stephen
2025-08-20 21:04:56
i have a 1992 ford explorer and i couldnt find a intake hose to save my life i had to duck tape mine literally and then i came across this and was skeptical cause i know a explorer and ranger dont always work together parts wise but this was extremely easy to install and now my car is running much better these guys did a amazing job and extremely fast i see people having hard time but just make sure your air flow is correct i would buy from and recommend these people again
Ben Jones
2025-08-03 10:15:59
Great product . Don't like so many PCs.Two many places to come apart.the rubber gasket doesn't fit the air intake to the map sensor casing but made it work.looks great solid pipe.
ROBNUTZ
2025-07-28 20:47:55
I installed this on a 1993 ranger splash 4.0, the install was easy and straight forward, everything that came in the kit was the correct size and even supplied me with a smaller tube for the breather that i installed inside the bigger hose (kinda used as a spacer) and clamped down the little filter to the oil fill tube, you must disconnect the negative terminal on your battery, when you are finished the install, your truck may feel sluggish thru parts of the RPM band but the computer is relearning the mass air flow to accommodate the bigger intake. Continue to drive around and it will clear up! great product and would certainly recommend.
A-A-Ron
2025-07-17 16:06:06
The media could not be loaded.
swede
2025-06-10 13:09:26
I have 94 explorer and my factory plastic intake tube was disintegrating due to time and 30 years of heat cycles. I looked around on the web for a factory replacement or an aftermarket one and this is sadly about it. If you don't have any skill at fabrication or knowledge of basic tools, this may not be for you. I got this to work but it definitely requires some effort. The supplied "bracket" and it's use is pretty much open to interpretation. I did use it but I had to drill extra holes to yest fit and mount. The tubes do contact the hood, and come dangerously close to the positive battery terminal which could start a fire. I insulated mine with rubber flex seal patches and a battery terminal cover. If the manufacturer would only make this to fit the factory airbox, I would give it 5 stars. The quality just isn't top shelf, and an open element air cleaner is always susceptible to water being sucked into the engine causing major damage. If you take your explorer off road, keep this in mind, and consider fabricating something more off road or mud puddle friendly.
Dallas Davis
2025-05-18 12:57:38
I liked that it fit perfectly with no modifications needed.
John C
2025-04-08 18:32:55
You get what you pay for. For what it is and the price it’s not bad. The aluminum pipe you get is thicker than most other cheap cold air intakes. Don’t really care for the cheap silicone couplers but again you get what you pay for. There’s a lot of room for activities so fitment is good.
Jd
2025-01-10 17:12:40
Overall good parts it fits and works perfectly on my 93 ranger xlt I just think they need better directions included
Recommended Products
