Your cart is empty.
Your cart is empty.Product Description
Jeremywell Pillow Block Bearings
Pillow blocks are the most popular choice of mounted units, providing shaft support. The UCF pillow block mounted bearing series has four bolt holes, and a set screw lock is designed for mounting onto bearing surfaces parallel to the shaft axis, such as conveyor belts. This one-piece pillow block housing allows for a stationary outer ring and rotating inner ring. Insert bearing maintains the separation between moving parts to reduce rotational friction, and to support radial and axial loads. The bearing is secured to the shaft with set screws to prevent slippage. This mounted bearing is used in food and beverage manufacturing, textile industry and many other industrial manufacturing.
Self-Alignment Feature
If the bearing is crooked for example when you lay it on a flat table, it is not flat. Please don't worry. This is our self-alignment feature. These bearing are meant to have some play in them. When you mount them, just use the shaft to rotate the bearing into proper position, or if it is not out of alignment by much, the bearing will correct their own alignment once they begin to rotate. Because if the bearings were not aligned properly and spinning at high RPMs then sure disaster would happen. So our self-alignment feature is a way to prevent this from happening.
Customer
2025-08-27 16:57:31
These bearings do exactly what they are supposed to. Correct size bore for my 3/4" steelrod. Seem very solid and the grease zero makes it easy to maintain. All in all perfect for my application.
John M.
2025-06-16 13:59:06
Making a custom weather wane. Using two bearing for better support
susan m.
2025-06-01 12:02:16
Exactly what I wanted- firs great!
timothy cress
2025-05-19 11:12:02
Good value
edward
2025-04-26 14:50:24
I received these and read the reviews where one of the bearings was out of alignment. Well mine had both out of wack. Put a 1/2†bolt in them and tapped them lightly and the paint broke loose to set them center. They are designed to allow for some slop if your flange mounts are not exactly parallel. Don’t panic, just use a little elbow grease to break them free and they will align correctly.
mike trickett
2025-04-12 12:20:25
Like the cost
ponyxpress79
2025-02-26 17:12:38
Used these for my water wheel. They work ok, but after running for a day, the wheel slowed. I greased just a dab in the zurk fittings and the wheel just barely moves. Spun the wheel for a bit and no improvement. I will be taking the wheel down and see if I can resolve the problem.
Stacey
2024-12-20 11:10:52
The diameter of the bore measures .5950. .They are supposed to have a 5/8†inner diameter bore, that is .6250â€. They are .0250 to small, that is more than 1/16!! quality control is way off.
Recommended Products
$22.29
$ 11 .99 $11.99