Your cart is empty.
Your cart is empty.Product Description
- We delivering products that are designed to elevate your projects to the next level. Whether you are a hardware engineer,hobbyist, student, or professional.
- Our development boards and components are here to help.
- Welcome to JESSINIE, for development boards and electronic components.
- At JESSINIE, we providing a wide range of development board modules, displays, sensors, electronics, power accessories, and DIP sockets to meet your project needs.
- At JESSINIE, We focus on the importance of reliable and efficient products, we prioritize quality and performance in everything we offer.
- Choose JESSINIE for your development board and electronic components needs.
- Thank you for choosing JESSINIE.
- Product features:
- 1. Detect ultra small blind areas, easy to use.
- 2. Wide power supply range and low power consumption.
- 3. High measurement accuracy, high resolution.
- 4. Equipped with corresponding upper computer testing software.
- 5. Diversified output modes, pulse width output, serial output, switching output.
- Specifications:
- Working voltage: DC: 3.0-5.5V
- Working current: less than 8mA
- Probe frequency: 40kHz
- Maximum range: 500cm
- Nearest range: 2cm
- Distance accuracy: ± 1cm
- Resolution: 3mm
- Measuring angle: 60 degrees
- Input trigger signal:
- 1. TTL pulses above 20uS
- 2. Serial port sending instruction 0X55
- Output echo signal: output pulse width level signal, or TTL
- Wiring method:
- 3-5. 5V (positive pole of power supply)
- Trig (control end) RX
- Echo (output) TX
- GND (negative pole of power supply
- Product size: L48 * W23 * H10 mm Working temperature: - 20 ℃ -+70 ℃ Product color: PCB board is blue
- Product Application: 1. High precision distance measurement 2. Robot obstacle avoidance, automatic control 3. Object approaching, presence detection 4. Artificial Intelligence, Scientific Research Experiment 5. Traffic, security, industrial control Note:
- 1. This module should not be connected with power. To connect with power, first connect the GND end of the module, otherwise it will affect the normal operation of the module.
- 2. During distance measurement, the area of the object to be measured should not be less than 0.5 square meters and the plane should be as flat as possible, otherwise the measurement results will be affected.
Crazy Cymbal Monkey
2025-01-31 14:19:18
An extremely useful, and well documented piece of kit. These were great for using with an arduino for making a simple DIY backup parking sensor.
Recommended Products
$36.00
$ 16 .99 $16.99