Your cart is empty.
Your cart is empty.JW Winco's Aluminum clamping hand knob. Lightweight yet long-lasting, these four-prong hand knobs made from a durable aluminum extrusion are an economical choice for a variety of equipment applications. Made of aluminum alloy 6063-T5, etched and clear anodized finish, RoHS compliant.
A.K.
2025-08-07 09:58:05
I was afraid the thread might not allow me to thread through based on earlier review, but the knob had a good thread all the way and I use it often on a long threaded rod to adjust pressure on a plate. Good knob, would use again.
Don/NV
2025-07-16 18:57:06
These are really strong, so the threads do not strip out compared to the plastic handle knobs. Very satisfied with this product.
Customer
2025-07-12 11:54:06
Loses a star solely for needing a tap run through it to clean up the threads. Luckily, I've kept that size tap around for years, so it was a 2 minute job. But the manufacturer should chase the threads first.
Cody O.
2025-06-09 12:59:23
Fine craftsmanship, even if that compliment only goes toward the machine that cut the product. Only problem is is that the product I was supplied IS NOT a 16 thread. So thanks to the seller whom apparently has no understanding of basic thread standards, I must now go and hunt down a bolt to fit. I run a wood shop and have found that this products I received fits nothing between a 14 count to an 18 count. Though it will thread to a 16 count about 1/4" before seriously binding without any burrs or debris present. I required this knob to repair a broken set knob on a vital piece of equipment in my shop and I was sent junk. Will not be buying from this seller again.
yodasbrudda
2025-04-17 14:25:10
Fantastic product. These were perfectly threaded with no burrs or any defects. They spin freely on my bolts and have a nice size for hand tightening. Highly recommended if you need some large knobs.
Customer
2025-04-10 14:21:28
Very high quality knob. Smooth Al finish feels good to the hand. Well machined threads, spins off & on nicely.
Long-time Customer
2025-04-05 14:52:24
Replaced broken lock nut on my Delta Contractor's saw depth adjustment wheel.
Oxblood
2025-01-07 18:37:43
Nice solid knob, much better than the plastic ones with inserts. One star knocked off due to the threads not being cut all the way through. I was able to use a little cutting fluid and a bolt to cut the last couple of threads for my application.
Recommended Products
