Your cart is empty.
Your cart is empty.Product Description
Wiring Method:
Red - Power Positive Pole/Main Power Switch DC 12V
Black - Negative Pole
Blue - LED Light
JAlmanzaD
2025-08-24 18:45:04
Excelente calidad
Kyle
2025-08-08 15:37:09
I got the wrong size plug 2 times
Chad
2025-07-26 10:16:24
It does what it’s supposed to do and easy to install.
Rich Ellis
2025-05-24 18:21:13
Second unit I’ve purchased. First displayed Err message right away. Ordered a second, worked on trial fit, dead on installation. Yes I checked connections/fuses/direct connection to battery (correct polarity) - still dead. Better to pay the extra for a higher quality item.
Patrick Jeremy Bucu
2025-05-15 17:05:19
Koso always make a good job
Rod
2025-03-01 18:38:50
Works fine now . But after inst did NOT work checked for problem found pins in extension wire had not been properly installed .
Tomas Anderson
2025-02-04 14:05:42
Installed on 2016 Yamaha FX Cr. SVHO to monitor engine cooling temp. Installed on a Thermostat hose on the block head, with their 22mm hose adaptor. The T-Stat hose is 20 mm ID, so 22 mm adapter is good for that.Wired + Positive to 3amp fuse that feeds Bilge pump and the - Neg. engine block bolt.Works well, as i checked the sensor Temp reading before installing and it reads correct temps.The only problem is that wires are way to short, i had to extend and lucky i found shielded wire so it was doable. But had to solder and install heat shrink tubing as well so it took an extra effort to make it right. Display is bright enough to see in the Sun. Reacts quickly to Temp changes. So far only used it for one ride (3hrs) hope it lasts long time.
Recommended Products
$83.56
$ 40 .99 $40.99