Your cart is empty.
Your cart is empty.Product Description
4" Oscillator Round Shaker
Round Base Vibrator
- Adjustable\Universal\Reverse-pull Headgear
- Voltage:110V/60Hz+-10%
- Power:120W.
- Easy operation
Tips:
- When adjusting the knob, the speed should not be too fast. Slowly turn the knob from small to large or from large to small.
- The power should be cut off after use.
- Always scrub the surface of the body and keep it clean to extend its life.
Key Features
Works as intended
2025-07-24 19:07:34
Works just as it says
Mank the old Squid
2025-07-13 11:34:16
I use this for making plaster positives of dental agar negative impressions for my family. I make my own dentures and my family's dentures. This vibrator works flawlessly in removing the bubbles in the plaster molding process. Make sure your plaster is soupy like a thick but watery pancake consistency. Then, when you mold up the impression, hold it firm to the base of this vibrator for at least 30 seconds. The goal is NOT to vibrate the mold, but to vibrate the liquid PLASTER. Hold the impression tightly to the vibtator base for at least 30 seconds. That works great for me. For the cost, I recommend this. Vibrate the plaster, not the mold! Hold the mold tightly to the vibrator base!
Edmond R Russell
2025-06-07 17:03:12
Using it for resin pouring and it works great for getting the resin into small places.
Steve S
2025-04-15 15:49:04
The instructions included with the unit specifically state that it may not provide maximum vibration until it has operated for 5 minutes! Unbelievable. I've only plugged it in to verify that it runs at all. It does. I think the vibration level will be adequate for my needs associated with woodworking.
Huntorg
2025-02-12 19:55:49
I’m so glad I got this lab vibrator to clean my electronics. I regularly clean out tough clogs of specialty inks from my electronics. I had a tough clog that I worked for a week soaking in various solutions with little effectiveness. After placing a unit on the platter in a Pyrex disk, I slowly turned the dial up to an acceptable level. Within 20 seconds it completely cleared out a clog that soaking for 7 days straight couldn’t do. Maybe soaking loosened it all up, but I needed this tool to vibrate it all out. Can’t wait to use it again.
Justin G.
2025-02-06 13:15:29
I ordered this vibratory lab table for the loading of TSS shotgun shells for turkey hunting. Several of my favorite load recipes call for buffer mixed in with the shot, this vibratory table fit the need perfectly! This also works great for 100%+ case capacity rifle loads where you need to condense the powder as much as possible before loading the projectile. I’m sure it would work just fine for lab needs also. I have already recommended to several of my fellow reloading buddies who have also purchased this product and are very satisfied with it as well.
Odontólogo Bogota
2025-01-29 16:29:25
Muy buen producto
Jessica
2025-01-06 11:43:24
Arrived and wouldn't turn on. I opened it up and the cheap board has multiple faulty solder points also the ground wire was just bouncing freely unattached rubbing against the live wires that were soldered and only wrapped with cheap heat shrink... stay away from this product. It's dangerous and extremely cheaply made.
Recommended Products
$7.99
$ 3 .99 $3.99