Your cart is empty.
Your cart is empty.New Lamb Ametek 119631-00 conical design motor is 2-stage 5.7 inch 120 volt. It has more than a 1/2" taper at the bottom (see additional picture). Replaces the old Ametek motor #119708 motor which is less powerful. It is suggested you replace the motor gasket part #MO512 . Protect your motors from dust and dirt by using a motor filter. This prolongs the life of your motor and is a must for all motors. See our part #MO553 . Uses motor brushes part #MO523 . Motor Specs Motor Type: Bypass Discharge: Tangential Bearings: Double Ball Bearing Sealed Vacuum: 128 inches Maximum Air Watts: 515 Maximum Air Flow: 114.5 CFM Maximum Amp usage 14.4 Motor Speed: 28 743 RPM
Deirdre
2025-08-05 12:17:53
Motor was shipped with 24 hrs of ordering, and delivered days earlier than the estimated date. It was an exact OEM replacement for the Beam whole-house vacuum motor that had failed.
AjG
2024-12-19 12:36:44
This unit was an almost perfect replacement for my existing motor (PN 6600-1 ECV B9 ECP) in my Centralux central vac. Two small problems hence 4 stars instead of 5.1. As mentioned elsewhere, the thickness of the METAL housing on the new motor is less than the original Plastic. I had to put on a spacer on each post (0.75" OD, 0.3" ID, 0.250 thick). You could use a bunch of washers. I just 3d printed 3 of them in PETG 50% infill. The distance from the mounting face (underside) to the bottom of the motors was the same, so the foam sealing washer on the bottom should be properly compressed.2. The original motor had spade lugs on the motor end. The new one had wires, so I just spiced them onto the existing spade lugs on the control board end.The motor is well constructed, and has an all metal blower housing versus the plastic of the original. The brushes look easy to replace.
Brian
2024-12-10 17:41:49
This is a great replacement for a beam central vacuum.
Recommended Products
$14.99
$ 7 .99 $7.99
$69.99
$ 29 .99 $29.99