Your cart is empty.
Your cart is empty. LCWRGS Auto Parts Co., Ltd offers a wide range of professional suspension kit to the aftermarket, including control arms, ball joints, sway bar link, tie rod ends etc. We take pride in offering premium products that are designed to meet or exceed OE standards, and we are confident that it will meet your expectations.
Fitment:
2003-2006 Chevrolet SSR (2WD/4WD)
2002-2009 Chevrolet Trailblazer (2WD/4WD)
2002-2006 Chevrolet Trailblazer EXT (2WD/4WD)
2002-2007 GMC Envoy (2WD/4WD)
2002-2006 GMC Envoy XL(2WD/4WD)
2004-2005 GMC Envoy XUV (2WD/4WD)
2004-2007 Buick Rainier (2WD/4WD)
2003-2008 Isuzu Ascender
2002-2004 Oldsmobile Bravada (2WD/4WD)
2005-2007 Saab 9-7X
Package:
2x Front Upper Ball Joint - K6664
2x Front Lower Ball Joint - K6663
Customer
2025-07-25 14:42:56
Fit perfectly great price will order again
ron cross
2025-07-21 17:27:11
The ball joints are alright. Not the best. If you are looking for something cheap to get you by for a bit these will work. The lower ball joint was a fight to get pressed in. I put my lower in the freezer for an hour before attempting install. Before I started the install I wire wheeled the lower control arm receiving hole. Then warmed up the control arm receiving hole with a map gas torch. Next put a small amount of general grease on the ball joint. Tapped the ball joint in a bit so it was square and began pressing. Even with all the precaution measures it still took a 3 foot 1/2" drive ratchet to crank it in with the press. Tightest ball joint fit I've ever dealt with and I've done alot. The original ball joint was 1.68" and these are 1.71" at room temp so slightly larger. Freezing brought it to 1.687".The top ball joint went right in with an electric impact gun. Takes 2 minutes to change. Seems like they aren't greased well from the factory so seeing how there is no fitting for grease I used a needle grease adapter under the bellow before install.
KELLY Rockwell
2025-06-19 12:06:31
Everything was lose in the package
Lee_Van_Cleef
2025-04-20 14:26:17
Went to install the material where the cup seat against the ball joint to press it in, rolled over and bent. Not going to waste my time with this garbage. Returning them. I should of have known better. You get what you pay for. I will not make this mistake again. Pay a couple dollars more for something quality not this trash.
S.Michaels
2025-03-11 16:56:20
Lasted 6 months. Don't bother with these.
Nathan
2025-02-19 13:11:13
No grease zurk and had no grease in them, loose, would not trust for a minute. Exchanged for original Delco item.
Customer
2025-01-31 21:50:31
These lower ball joints don’t fit! Spent 8 hours trying to press them in and wouldn’t go past half way for anything. Put 1000 ft pound and wouldn’t budge. Went to Autozone and purchased new ones and those when right in. Lost a day of my life
Recommended Products
