Your cart is empty.
Your cart is empty.Activates a device 24V AC/DC 310 MHz, 8 dipswitches
geterdone handyman service
2025-09-01 17:38:04
It only took about 5 minutes to remove the 3 wires from the old controller and reattach on the new one..it's working perfectly
vince
2025-08-05 15:03:18
If you had an older model, you might need to use the opposite code on the receiver than your push button garage door opener. The newer switch board is reversed. Hope this helps. Easy Install.
Allison
2025-07-19 11:51:56
Works great. Took a little longer to get to me than I would have liked. About 2 weeks
Customer
2025-05-24 13:39:27
Easy installation.
TWPiteo
2025-04-04 10:12:17
This receiver is an exact match replacement for grandparents original garage door opener receiver that was many years old. The receiver was well packaged and included the mounting bracket as well as the instructions for setting the receiver's and the remotes DIP switches.The setup and installation of the new receiver took 10 minutes at max and it works perfectly with the two original remotes that are decades old.
Heath Negus
2025-03-27 16:46:47
This same opener receiver / remote have been made for many years and they just plain work. Set up is extremely simple, match the dip switches in the receiver and remote then connect 3 wires to the opener.Best one out there!
Customer
2025-02-21 13:36:18
This is my third order. I thought it was an issue with my garage door, but it seems to be the receiver goes bad. Longevity on these receivers is two months.
Wha123
2025-02-13 18:44:26
Replaced old receiver on old gdo and working well
Michel st-pierre
2025-02-02 17:38:21
Le recepteur ne fonctionne pas
Recommended Products
