Your cart is empty.
Your cart is empty.Seymour Link Handles Each handle comes with the required wedges, rivets, or epoxy needed for proper application to the tool head. Quality level code is 19, better clear lacquer, fire finish, contractor or homeowner.
Brian B.
2025-09-04 13:00:11
The media could not be loaded.
Winston Wolfe
2025-07-28 11:44:47
I purchased this handle to font in a 16 ounce claw hammer head. Installed easily with a little shaping and sanding as to be expected. I was done in less than 20 minutes.I like the finish, the look, and the feel in my hand as I use it. Would definitely buy again for a similar hammer head.
Jamie
2025-07-18 15:03:10
The handle I received has a pretty severe twist along its entire length. So much so that the head of the hammer is about 10-15 degrees off to one side. Need better quality control before these leave the factory.
Ernie White
2025-06-09 11:27:38
I read the reviews before I bought this and one did stand out. I did not listen when I should have. These handles are machined crooked so that when installed the octagon shape is twisted from the head. It is a factory machining issue and not an install problem. If you care what your hammer looks like, don't buy this handle. I'm sure they work but they look like a mistake. I burned mine. On the upside they are solid and nice looking.
Michael C Cramer
2025-05-22 10:18:31
A few days after rehandling a hammer I broke, I tried to use it and found the new handle is so warped it's useless. I would ship it back for a replacement, but it's already installed. Wish I would have taken a closer look at the handle before installing it!
namtrof6
2025-04-27 12:09:57
Fit my hammer well
marie
2025-04-16 10:34:31
Definitely a good addition to my toolbox.
Nick
2025-02-08 14:16:12
Resin was wildly bobby
Recommended Products
$18.97
$ 8 .99 $8.99