Your cart is empty.
Your cart is empty.Cleans Threads in Soot Sensor Holes. Use with 7/8" hex socket or 3/8" square drive. Important: Use anti-seize.
Nolan
2025-09-03 16:12:28
Great for replacing soot sensors, they are always a pain. If your lucky and get it out without pulling all the threads or just breaking the bung off then you need this tool.
AMAZON SHOPPER
2025-08-28 13:29:02
the thread pitch is correct so I'm happy
Enrique
2025-08-09 11:51:47
Good
Anonymous
2025-07-22 13:00:21
Just what I needed for thread repair
Mustache Mike
2025-07-14 15:22:01
I bought this to try to restore the threads when I took the particle matter sensor out of my Ford 6.7 diesel exhaust. It would’ve worked great if I hadn’t messed up my threads so bad it would work great for cleaning up threads but the stainless seem to be too hard to restore threads that were badly damaged, but I would buy it again for the next time
Joseph M.
2025-06-01 20:08:07
Works great
CTR
2025-05-27 16:56:51
I bought this to chase AIR injection port threads in one of the steel tubular exhaust manifolds on a 1986 Chevy. They are also M22 x 1.5. The only issue I had is the pilot on the end of the tool prevents it from threading into the manifold all the way before bottoming out(not a problem if using it for it's intended use). I chose to face it off in my lathe. Also, as with all cutting tools use a good quality cutting oil. Ridgid Nu-Clear is my go-to. These will also work on Cummins oil pans that use a M22 x 1.5 drain plug.
Nikki
2025-05-05 13:09:15
This little beauty saved my husband from having to cut the old threads off and weld a new piece on my exhaust.. Was a pain in the butt for him to rethread the pipe but working it in a turn and backing it out with lots of lubricant is they key its just tedious if its a hard to reach spot.
Harold Ramstad
2025-04-16 13:42:17
Would like to send back. Came up as a tool for the socket I bought for my box sensor. Pleas send me a return decal.
Rajesh Chohan
2025-02-16 12:09:18
Good
Uno
2024-12-29 13:12:37
Liked the quality
Mark Price
2024-12-21 16:37:23
When removing a stubborn vaporizer nozzle from a transit Dpf, it damaged most of the threads. With this tread chaser I was able to restore the threads and avoid a costly Dpf replacement. Tool arrived faster than a replacement filter would have. Must have tool when working with newer diesel engines.
Eric
2024-11-24 10:50:30
I especially use this for cleaning up axle nut threads. On axles that measure 22 mm x 1.5 mm. I run this thread chaser through the axle nut just to make sure that there’s no defects. Now I am less likely for the axle not to pile up and cross thread on the axle shaft.
Recommended Products
