Shopping Cart

Your cart is empty.

Your cart is empty.

LTKJ 5pcs Titanium Ti Grade 5 Gr.5 GR5 Metal Rod Diameter 3mm, Length 25cm 10 Inches

Free shipping on orders over $29.99

$7.65

$ 3 .99 $3.99

In Stock

About this item

  • 【Size】- Diameter 3mm x Length 250mm
  • 【Feature】- small density (4.5kg / m3), high melting point (1660 ℃), high corrosion resistance, high strength, good plasticity
  • 【Application】- aviation, aerospace, chemical, shipbuilding and other industries widely used, manufacture gas turbine components.
  • 【Advantages】- Excellent corrosion resistance, good thermal stability.
  • 【Package】- Package Includes 5pcs x Titanium Ti Metal Rods


10pcs Titanium Alloy Bar Metal Shaft Bar Round Rod 3mm x 250mm Titanium Rod - Materials Metal Rod -5pcs x Grade 5 Titanium Ti Metal Rod


Christian chico
September 5, 2025
It worked lol
David
August 23, 2025
I'm only writing this review so that people will know that as of this date, at least the rods I ordered were all solid as advertised (contrary to what another reviewer said they received). I have been cutting these rods into 1-inch lengths, for a special electrolysis project, and so far all have been solid.
Customer
June 8, 2025
The media could not be loaded.
greg
April 26, 2025
Use it as anodizing rods for aluminum and is definitely acid and anodizing resistant
Dan
April 19, 2025
I used these for hinge-pins for a RC drift car’s suspension arms. I created 4 pieces 46mm in length and two pieces 27mm in length with a notch in the middle for a set screw.They are indeed solid, stiff and light. They are quite hard, and slightly difficult to machine with hand tools. To cut them i used my Dremel with a cutoff wheel, then changed to a sanding drum to flatten the ends. I used my dial-caliper to check length and chucked them into my drill with a wrap of masking tape. I spun them and took off a little material at a time until the correct length was achieved.The only reason they get a 4-star instead of 5 is that they are actually oversized a bit at about 3.04mm diameter. This required chucking them into the drill again and sanding them down - very time consuming.It was an interesting experience, and I am satisfied with the results. However, for my next build, I’ll probably just order stock steel hinge-pins.
Buba @dailyhustletactical
April 13, 2025
Minus having to clean up the ends. These are perfect
Fgod
March 29, 2025
I dont know how these could be titanium they're so much easier to bend than a steel rod of the same size. it's like putty
Stevo
January 19, 2025
Items arrived late but the bad news was when I started to get to work on them and discovered they’re not rods but tubes - hollow inside. A clever trick and clearly advertised falsely. Buyer beware. 1 star because some score is required. Zero ideally. Waste of money.