Shopping Cart

Your cart is empty.

Your cart is empty.

Matek 150A Hall Effect Current Sensor for Carbon Fiber FPV Racing Drone Quad Quadcopter Frame

5.0 Write Review
Free shipping on orders over $29.99

$23.69

$ 11 .99 $11.99

In Stock
  • No voltage drop and heat on current sensor components
  • Offset and Sensitivity are calibrated in factory
  • Continuous current rating: 0~150A DC
  • VBAT voltage sense: 0~69V, INAV scale = 2100, BF scale = 210, ArduPilot BATT_VOLT_MULT = 21.0
  • 5V: power supply for HCS-150A board, support 4~13V IN, 17mA


No voltage drop and heat on current sensor components
Offset and Sensitivity are calibrated in factory
Continuous current rating: 0~150A DC
Sensitivity: 20mV/A, INAV/BF scale = 200, ArduPilot BATT_AMP_PERVLT = 50
VBAT voltage sense: 0~69V, INAV scale = 2100, BF scale = 210, ArduPilot BATT_VOLT_MULT = 21.0
Power Consumption: 17mA
Voltage offset error at zero current : +-10mV
Curr output voltage error: 5%
Operating Temperatures: -30~80 °C
23 * 20* 23mm, 7g

 Soldering pads
Vbat: for voltage sense, support 0~69V IN
Volt: = 1/21 Vbat, 0~3.3V out
Curr: Current signal, 0~3.3V out
5V: power supply for HCS-150A board, support 4~13V IN, 17mA
G: GND
TX/RX: for firmware update and configure (to be supported)

Tips
mount Hall sensor far from iron and magnetic material