Your cart is empty.
Your cart is empty.Micro Edge Finder And Center Finders Set Of 4 Pcs Double End & Single End
Rex Giles
2025-08-27 14:49:44
For the money you can’t go wrong. I’ve had these about 5 years and still using them
William Leard
2025-08-07 13:25:26
They simply do not work, they don't kick out when you need them too. Out of the entire set I was capable of doing work with only one of them, other machinists in the shop scoffed at the quality, they'd never seen anything this bad before.And with the one that I was actually able to use, you basically had to squint and you could barely see it kick out and have your face two inches away from your work.
bluesux01
2025-08-04 16:34:05
Never have I seen a better case of you get what you pay for, they appear to be good quality until you try to use it on precision work. If you have to rely on an edge finder for finding location on machines parts do yourself a favor and buy a name you know.
Franky D
2025-07-01 19:09:57
I broke my edge finder due to a jump scare at work so I went to find a replacement and found these. They seem very tight and a little rough around the edges, hope that with some use they will break in. I went with quantity on this one hoping for quality too. Bottom line so far to me is that you always get what you pay for. They do offer great customer service I have to say though.
Daniel K.
2025-06-08 13:15:49
don't buy unless it's for a garage shop they're so tight you can't even tell when they Hit an edge.other than that accurate.
Paul
2025-05-05 14:57:52
A
Landon vaughn
2024-12-31 12:15:08
I used these one time at work and two broke but mine was very tight to begin with
Craig
2024-12-05 12:22:30
Correct size, they work. A little tight, but I assume this will change the more I use them.
Recommended Products
$21.04
$ 10 .99 $10.99