Your cart is empty.
Your cart is empty. Operation steps
Insert the batteries of AA type with full power in the transmitter.
Power on the controller according as the power on mode.
(Turn the knob key switch to ON and press START.)
Operate the transmitter on the buttons function.
Handling after operation:
(1) Press emergency button
(2)Turn off the key switch and pull it out.
Take out the batteries if it would be not used for long time.
Safety Features
Each radio remote control system function in all manner of operational conditions equipped with their own unique identity code(ID-code).
this means that only the correct unit can activate and control its matching receiver(crane/machine)for maxmum safety.The system is with FCC and CE certificates.
Troubleshooting
The transmitter is with two alkaline AA batteries. The LED indicator flash green after pressing
the button if the batteries are full electric. Otherwise the LED Indicator flash red or does not
flash if the electric is not enough. Then the batteries should be changed soon.
TX LED remains ON with red light. Solution: Please remove the batteries and insert again.
The RX does not respond at all. Solution: Turn the main power off for 20 seconds and turn it on again.
I.weld.4.$
2025-08-24 11:01:21
The media could not be loaded.
Jorge E.
2025-08-18 16:31:41
Very good product
Colby C.
2025-08-06 17:20:19
Looks like a solid product, but didn’t work for my application.
DrNautica
2025-03-04 10:58:10
No manual or paperwork was included showing how to install. I’ve researched online but no workable diagram was found for my Parstam 2200# hoist.
Kyle Allin
2025-02-25 19:25:52
Worked great! I used it for a garage attic elevator I made and was exactly what I needed to be able to put it up when not in use from the ground.
gamer
2025-02-11 19:20:36
Unable. To use this.. It didn't work
Customer
2024-12-21 15:51:45
It is very convenient to match my 1320lbs Automatic Lift Electric Cable Hoist.
Angelica Vega
2024-12-15 20:03:55
Easy to install works great!
Recommended Products
