Your cart is empty.
Your cart is empty.1/2" NPT mid-size regulator is the relieving type which offers stable downstream air pressure over a wide range of air flows with accurate control, fast response and minimal pressure drop. Regulators should always be preceded by a filter to eliminate damage to the unit or inaccurate air flow. The aluminum die cast body comes with a balanced piston, molded rubber seat, Buna-N diaphragm and O rings. This regulator also has two offset 1/4" gage ports which can serve as two 1/4" supply lines. Offers a maximum inlet pressure of 250 PSI and 100 SCFM.
Laserman35
2025-08-20 17:02:55
It is made well.
Tinker Bert
2025-06-07 13:34:17
the Amazon listing said "Made in China". Having used Milton products for years I was disappointed.However when it arrived the box, and the regulator were labeled "Made in USA". The fit and finish show high quality, and it performs as it should.
Gassius
2025-06-04 12:18:19
So far, so good. Build quality is excellent and it's a regulatin'
William Linden
2025-05-11 14:24:42
So far so good, I bought this regulator to replace and older one on my compressor. Seems like a good quality regulator and is working fine.
Carl Teixeira
2025-05-07 17:37:36
I like the Milton product line. I have used their products for years and have not had any issues. This regulator has worked as advertised and is priced good. I have used other products that were cheaper and they were "cheaper". I have also used others that were more expensive, but were "cheaper" in construction. So for me this regulator does the job.
Melo
2025-03-19 20:10:49
Used on my 60gal compressor I think the t-handle for adjustment is better than the plastic knob I had on the old one
Life is just a vapor
2025-03-11 15:34:02
Good quality
Travis
2025-02-23 16:18:58
Works just like it’s supposed to
Dave Anderson
2025-01-16 14:31:58
Works great at knocking down the pressure on my two stage compressor. Usually keep it at 90 but have used it at 50 for blowing out sprinklers. My only complaint is they only include one 1/4†NPT plug but there are two 1/4†tapped holes. It’s fine if you’re putting a gauge in one but I wasn’t.
Recommended Products
$21.99
$ 10 .99 $10.99
$96.18
$ 43 .99 $43.99
$40.58
$ 20 .99 $20.99