Your cart is empty.
Your cart is empty.This silicone radiator hose kits are made with a dual layer combining high grade silicone and heat-resistant embedded fibers to provide efficient heat reduction and increased pressure tolerance, all with an OEM replacement fit.
Ben Whitney
2025-09-03 10:31:20
Fit my 2010 370z perfectly.....read all the reviews that said these need to be cut to fit. I cut the overall length by about 3/8" and once I put it on it was a little short. Did not cut the other side and it fit perfectly. The small PCV (positive crankcase ventilation) hoses did need to be cut but it literally took 2 seconds. So when you install these do not cut the overall length! Not nearly as easy to install as the stock ones but just requires a little squeezing / pushing / pulling to get them on. Can use some soapy water to help slide them into place. I use this trick with forced induction intercooler piping but did not need to with these.
Jedi Knight77
2025-08-02 13:16:50
Went on very good already had my stock air boxes out which made easier. I have combined these with my JWT pop charger. After install looks good sounds good. You will have to trim just a little with the driver side nipple and maybe re route the stock air filter.
Chainsawkitty
2025-07-23 20:11:04
If you expect a perfect fit, this is not for you. If you don’t mind cutting to fit and then shove into place, then this is right up your alley. It is a good build quality and feel of thick silicone. I expect it to outlast the remaining days of the car.
Tony
2025-06-29 16:49:56
Good product, noticed better throttle response and low end torque, there was some cutting but nothing too bad, they are pretty hard to slip on oem box and throttle body but it’s due able. Pair these with drop in filters and you’ll get even better throttle response witch these cars tend to have laggy throttle. I’d recommend these if you don’t want to go long tube.
Customer
2025-06-10 10:06:41
Product arrived in great condition. Package includes 2 Tubes, and 4 clamps to keep in place along with warranty info, installation instructions and sticker. I installed them on my 2011 370z, it was easiest to remove the strut bar completely from the car to do the install.You'll only need a 14MM and 10MM socket to get this job done.
Ben R.
2025-06-02 19:42:23
Nice. It def increases throttle response. Hp gain, prob none, but still worth the upgrade. Def will need better filters to tie it all together. AFE or K&N filters only.
fred_snobble
2025-03-24 15:26:28
Nice idea. Wish it fit my car. Image 1. Maybe I could have pulled the bar and cover and found a way to make it fit but that is not what the description says. As the 2nd image shows, the idea is correct just not the fit. BTW, the pretty hose clamps are not included even though they are in the picture. Overall, a bad experience. Returned immediately.
Chris C
2025-03-11 11:18:11
Install was a little tricky due to it not being an exact fit. As others have stated i needed to trim the rubber down to make the side sections fit
Tclip
2025-03-09 18:19:47
My old hoses cracked and started causing problems, factory hoses are 3x the price. The silicon felt as though it was good quality and its been weeks now with no problems. I recommend using soapy water makes bending the hose into place easier.
Ravicheth I.
2025-03-02 16:12:18
Overall the quality of the product meets expectations. Although, please be aware there is one big draw back; the PCV inlet are too long (both sides) which will require cutting to ensure proper fitment
Tdomchainz
2024-12-28 11:11:30
Fit well on 370Z. Was even able to squeeze the inlet side over a 3†aluminum pipe when I put together a set of custom intakes.
Matt Wiebe
2024-12-26 13:45:39
Definitely way cheaper than swapping for another set of OEM. Install was pretty easy, bit of a pain on the passenger side, and a little trimming was needed, but overall it does the job, was relatively cheap, and definitely improves intake noise (on my G37x)
Joe S.
2024-12-24 17:24:18
It was a hell of alot cheaper than the infiniti replacement part. It looks great, not too thin (looks thin in pictures). The only thing that was a pain was getting the pcv hose on. You have to use a little common sense and patience.
Recommended Products
