Your cart is empty.
Your cart is empty.Product Description
Package Included:
- 2 x Brass 0.2mm/0.6mm/0.8mm/1.0mm nozzles
- 16 x Brass 0.4mm nozzles
- 10 x Stainless steel needles (With Plastic container for needles)
- 1 x 6 MM Inner hexagon wrench
- 1 x Storage Box
Compatible with most 1.75mm 3D printer.
SGS
With professional testing certificate, the quality is more guaranteed!
Nozzle size is marked
Nozzle size is marked for easy selection.
Contact surfaces fit tightly
Contact surface is smooth, solve the problem of material leakage of consumables, effectively prevent printing material leakage
International standard brass
International standard brass material, good thermal conductivity, high hardness, more wear-resistant, cost-effective!
Silky smooth
The inner wall is smooth and smooth, and the viscosity coefficient is small. Unlike most of the rough products on the market, the consumables extrude with less resistance!
Elysse
2025-08-14 09:12:32
These are just as advertised and you get plenty different sizes and a tool to use it properly. Way better print proformance and good durability to the tips. Easy to install and looks good. Works as it should.
MARIA BAILEY
2025-07-24 12:04:01
This is a great choice
Dwight
2025-07-22 17:17:46
Great variety.
Quasar0406
2025-04-09 17:06:35
Nozzles are always very cheap but they normally come in a huge pack of the same diameter. This has a good variety for cheap.(Note: These nozzles will not fit your Ender 3, you're looking for MK8 nozzles)
Lisa Chaney
2025-04-01 17:58:37
The XIFOWE K1 Hardened Steel Nozzles are a fantastic upgrade for my 3D printer! They handle high temperatures with ease and are perfect for abrasive filaments. Installation was straightforward, and I’ve noticed improved print quality and consistency. Highly recommend these nozzles for anyone serious about 3D printing!
Kevin Chang
2025-03-08 11:25:59
You get a ton of nozzles, along with tools for taking the nozzle out. Thank god it came with a wrench with a female end to slot and twist off the nozzle with, since I was going at it with a pair of pliers and getting nowhere.The little organizer is just a bonus, which I really appreciated. Having no problems with my prints since swapping
Will
2025-03-05 18:43:31
These fit the MicroSwiss All-Metal Hotend for the CR10s Pro V2. I got this because my original nozzle clogged up. I cleaned up the clog with the needles. I replaced my nozzle with a .4mm from this kit and it was printing fine until it clogged again. This time the clog happened in the hot end, so it isn't the product's fault. After addressing the hot end clogs, this thing prints as good as my $25 nozzles. If one nozzle doesn't work, you can just swap it out for any of the many spares that come with this kit. It is nice to have different sized nozzles for so cheap too. Two of the smaller needles did bend a bit when used, but there is only so much you can do to prevent such a small needle from bending. Overall, I recommend these.
Cohen Lafountain
2024-12-28 14:06:18
The media could not be loaded.
Recommended Products