Your cart is empty.
Your cart is empty.2.72", easy installation for protecting wheel bearings on 7000 lbs (7K) and 8000 lbs (8K) trailer axle hubs. Wide compatibility with 8 on 6.5 Trailer Axles 2.75" 7K/8K Dust Cap/Grease Cover
PhiNew
2025-09-03 16:38:13
I knocked a couple hub covers off my trailer wheels as I went through a woodlot. These fit perfectly, just make sure you have something like a pipe or large socket to fit on the lip and drive into wheel. The metal is very thin and if you tap on the cup with a hammer you will just dent it up. This isn't a detraction of this product, all of these type caps are very thin.
Maxim C.
2025-08-30 16:18:41
Great caps, using on my gooseneck 7k axle trailer
Brandon
2025-08-29 17:37:13
Replaced 2 hubs and covered my uncovered orginal hubs. Fit both without any issues! Be careful when installing. Use a board and a deadplow hammer to install. I didnt on the first causing a dent and mushroomed end. The other 3 are prefect after my oops
Chuck
2025-07-05 14:48:37
Fit as said
TL
2025-05-20 12:36:34
Not much to say about these but they do the job. Better values than what you can get off the shelf around town, if you have time to wait on short delivery and don't need them right now.
Dan T
2025-04-09 12:21:38
Replaced most cap on fifth wheel trailer. Works fine.
Customer
2025-03-28 18:34:32
Great quality!
Customer
2025-02-16 11:39:33
Fit my axles well and don’t leak
Gavin W.
2024-12-19 10:24:32
You will have to file down (chamfer) the leading edge slightly to get it started in the hub center. Otherwise you will stove in the cap hitting it too hard. Otherwise fits and works fine on 8k Dexter hubs.
Ian Morley
2024-12-16 10:38:44
Don't pound them to hard installing them
Recommended Products
$24.80
$ 12 .99 $12.99