Your cart is empty.
Your cart is empty.The 600 Series is designed for moderate speeds and medium thrust loads. These bearings utilize a full ball complement. Rings are cold forged from strip steel and are carefully heat treated. The entire assembly is housed in a soft steel band which lends itself to an easy press fit into a housing. The band also serves as a dust shield and helps retain the bearing lubricant. The upper ring is free to rotate in the band and has a close fit in the bore for the shaft. The lower ring is fixed in the band and has a shaft clearance in the bore. RBC Nice Bearings is a subsidiary of RBC Bearings. RBC Bearings has been providing bearing solutions to our customers since 1919. A publicly-traded company (NASDAQ: ROLL), RBC currently has 23 manufacturing facilities worldwide, with 18 located in the USA.
JR
2025-09-05 11:08:44
It worked as it should.
TheFox
2025-08-04 11:57:00
I have an old lathe. It needed a bearing that is the same as this one. I thought I was getting 1 for 10 dollars but I got a box of 10!! Greased it up and put it in. Works great!Now I can keep this lathe going for another couple dozen years!
HEMI-STOD
2025-07-12 15:54:28
Good price, brand name as advertised, and spins but not too much, which is also a sign of bearing wear.
markiz41
2025-06-16 17:19:59
American made precision. Just grease and go. Very NICE of seller to throw in a few extra ones.
SSG Thunder Lizard
2025-05-26 16:20:27
The size specifications were exactly listed. The bearings fit perfectly into the wheel assembly as intended.
Dan johnson
2025-04-27 15:17:25
Bought this thought I was getting one for 5.58 but was honestly surprised to find a box of ten at my door step. Idk if this was a mistake? But should last me years to come.
J.C
2025-04-03 17:32:29
made is Usa
J. Bruha
2025-02-21 10:09:32
Got this bearing to replace a bad one in a farm implement tongue jack. It fit fine, and works well. Not 'quite' as stout as the Bulldog brand, but for all but the heaviest loads, it should be more than fine.
Kosmo
2024-12-08 12:16:23
I think this will work. I am going to use on harley wheel bearing tool.
Rich
2024-12-04 18:25:03
Used this in my DIY rear subframe bushing puller for my BMW. Worked well for my application. Helped prevent any binding when I was winding the nut up against this bushing. Would purchase again.
Recommended Products
