Your cart is empty.
Your cart is empty.
The socket has a slotted design. So you can remove the oxygen sensor while still connecting the harness. This 3/8" drive oxygen sensor socket is also offset and compact, providing extra leverage even in hard to reach locations. The 7/8" (22mm) socket fits most oxygen sensors and can be used with any 3/8 " Used in conjunction with a drive ratchet or breaker lever, a biased drive gate with wires connects the sensor from the side to prevent damage to the wires.
Specification:
Item: Offset Oxygen Sensor Socket
Package Included:
1 x Offset Oxygen Sensor Socket
haydn
2025-07-11 19:53:10
having this tool to change my ox sensor made things so much better. i have removed sensors before however it was a pain. this tool made it so much quicker and easier. my only complaint is that the hole where the wrench goes was a little tight. Had to deburr the inside a little.
Luis Garibay
2025-06-06 13:01:31
Worked perfectly and was exactly as listed. Solid and can't complain for the awesome price compared to Auto store.
Kristin
2025-05-18 12:45:17
This socket worked great for replacing the downstream oxygen sensor on my 2012 Corolla. It is very durable, easy to use, and fit the sensor perfectly. This job is almost impossible without this tool because the exhaust heat and rust bind the sensor to the exhaust line. With a good socket wrench and this socket and a few light taps from a hammer it popped right off.
Wayne
2025-04-15 15:52:19
The fit and finish is a little off on this product, but it is usable. It is a decent value for the price.
Junior
2025-04-07 16:33:41
After reading all the bad reviews I still bought it worth every penny never had problems fitting my 3/8. Very easy to remove 02 sensors
bruce
2025-02-10 18:00:11
Very thick walled product compared to others that have thin walls and stretch and flex with stubborn O2 sensors. This one broke my O2 sensor free of corrosion easily
Roger Funk
2025-02-02 14:41:13
Easy to use
J&B Garrison
2025-01-24 15:06:56
Well it looks like a quality tool. Upon trying to use it I found that the square 3/8 inch hole intended for attachment to a ratchet or other 3/8 inch drive tool was too small and required a fair amount of filing in order to use it. Also there is no divot created to allow the detent ball on a ratchet to fit so it doesn't just fall off during use. The same old song and dance when buying cheap chinese knock off junk. Most of it looks like quality merchandise until you actually use it....
Ron
2025-01-12 10:58:24
Looks like a quality tool
Paul Peech
2024-11-23 11:07:14
made job easyer
Recommended Products
