Your cart is empty.
Your cart is empty.Shane Fuller
September 5, 2025
Haven't used this one yet but I have another one by the manufacturer and it works flawless
Bridgette
September 1, 2025
Very nice machining, nothing overly fancy but it will get the job done. It will not be the weakest link, it will be something else for sure.
Barry L. Brumfield
August 19, 2025
Made for 3/8" or smaller rope. V groove narrows to 2/8" at bottom and is only 3/8" deep, causing 1/2 of 5/8" rope to protrude outside of ring. Returning unused. Note, quality of build is excellent, but made for ropes smaller than 5/8".
H.Dale
August 11, 2025
Fast Shipping! Great product!
Jeep Pro
August 6, 2025
The large diameter keeps the bend wide and the groove shape keeps the rope from pinching or deforming. Friction was so low that there is almost zero heat buildup in the ring. I purchased 3 more since.
AlmostCorrectEngineering
July 29, 2025
This ring is smoothly finished and properly radiused on both the pulley groove and center donut hole for use with synthetic winch ropes. I prefer the large diameter pulley rings like this one for their good efficiency and strength
Garrett
July 3, 2025
Woooo this thing is no joke.For some reason i though this would be a light weight option to a traditional snatch block (my bad for not reading product specifications) it’s about the same weight as my traditional bearing snatch block. Appears to be good quality without any fail points. Will try and update after use. Have another on the way.
Tyrebyter
July 1, 2025
Stupid simple. If you're moving away from metallic missiles (my experience with recovery was with the Army in the '70s), then you're moving away from snatch blocks. This provides adequate radius to not stress the rope, and it is property machined and plated to provide a low friction surface. Highly recommend.
Dave Roche
May 27, 2025
Way to heavy it didn’t specify the weight when buying
michael c.
May 21, 2025
I use this to turn a line to pull over danger trees. Works great. EXCEPT: this pulley requires constant tension to keep the rope in the groove. If it loses tension even for a moment it will drop loose and the rope will run on the connector instead. Someone will need to reset it and carefully retension.
PG
April 14, 2025
I can't imagine this ever breaking. It's super robust.
Josh
February 17, 2025
Great product but nothing but shipping delays. Not entirely sellers fault, but they should revise the eta to be honest.
Bin F
December 9, 2024
Look good,nouse yet
Recommended Products