Your cart is empty.
Your cart is empty. Construction: Lightweight black polyethylene wall hose construction reinforced with an integral polyethylene helix.
Applications: Air.
ID Tolerances: -0.00 to +0.035 Inch
End Finish: Plain cut
Markets: A/C Ventilation, Bilge Pump Hose, Bus, Cab Ventilation, Circuit Board Cooling, Defroster/Heater Hose, Dust Collection, Electronic Panel Cooling, Insulation Blowing, Limo A/C Duct, Pipe Organs, Printing, Stereo Speakers, Woodworking & Furniture Industries
Size Inside Diameter (Inches): 3
Approximate Weight (LBS/FT): .27
Min Centerline Bend Radius (Inches): 4
Compression Ratio: N/A
Max Recommended Negative Pressure (IN/HG): 10
Max Recommended Postive Pressure (PSI): 11
Please Note: All hoses are measured when fully stretched. Hoses in their relaxed state may appear shorter than their listed length.
Linda
2025-01-02 12:53:44
I liked this hose as it was heavier then the hose that was on the cooling system
Recommended Products
