Shopping Cart

Your cart is empty.

Your cart is empty.

Performance Tool W84006 Oxygen Sensor Thread Chaser - M18 x 1.5 Size, Use with 3/4-Inch Hex Socket or 3/8-Inch Square Drive

5.0 (11) Write Review
Free shipping on orders over $29.99

$11.16

$ 4 .99 $4.99

In Stock
  • THOROUGH CLEANING: The Performance Tool W84006 Oxygen Sensor Thread Chaser effectively cleans threads in oxygen sensor holes, ensuring a proper fit and reliable performance.
  • EASY TO USE: This tool can be used with either a 3/4-Inch hex socket or 3/8-Inch square drive, making it easy to incorporate into your existing tool set.
  • UNIVERSAL SIZE: With a size of M18 x 1.5, this oxygen sensor thread chaser is compatible with a wide range of vehicle makes and models.
  • VERSATILE APPLICATION: Not just for oxygen sensors, this tool also works on M18 x 1.5 spark plug threads, making it a versatile addition to any mechanic's toolkit.
  • SAFE AND EFFECTIVE: The W84006 is not intended for use with an impact driver and should not be used as a tap. Follow the manufacturer's instructions for safe and effective use.


Performance Tool Cleans threads in oxygen sensor holes Use with 3/4" hex socket or 3/8" square drive Size M18 x 1.5 Also works on M18 x 1.5 spark plug threads


Osnaldo Saez
2025-08-26 15:38:15
Llego a tiempo buen servicio
M.D
2025-08-17 10:49:10
Not sure about this product. The code came up again even after we changed the sensor. Not sure if it’s the car itself or the censor is actually bad.
M. Owens
2025-08-06 14:53:22
It didn't work! I removed my O2 sensor and needed to clean out the threads, and it was chewed up in minutes! I purchased an M18 x 1.5 tap and die, and it did the trick! I tapped the manifold several times and it cut/cleaned out the threads easily! The metal that this product is made of seemed to be too soft, and was damaged very easy.
Louis
2025-06-30 11:29:34
Worth the purchase and easy to use.
S man
2025-06-26 16:27:22
Worked great I'm very happy with it.
William Lindsey
2025-06-19 13:34:33
Did the job. Worked really well and was a life saver. Priced great too!
Ricoh
2025-05-10 18:24:50
I use it every time when i replace O2 sensor to give a cleaner and smoother thread for the new replacement!But if the thread is badly damaged, you should tap it with M18 X 1.5mm instead, then thread chaser again!!
phill
2025-04-30 16:27:36
I bought this to clean the threads on my o2 sensor. It is not hardened steel. It damaged the threads to the point I almost had to buy a new manifold. (Very expensive on my BMW)
Chad Michel
2025-04-26 17:49:57
Worked perfectly and at a more reasonable cost than some other options.
Abdul Hamid Samad
2025-02-28 11:04:56
Not the best oxygen sensor thread chaser.
Richard Hebert
2025-02-17 17:42:58
VERY GOOD