Your cart is empty.
Your cart is empty.Product Description
How to install effectively to prevent leakage?
Jan Eric Welch
2025-08-20 20:44:29
The Pressure Washer Tips Turbo Nozzle is an excellent addition to my pressure washer setup! This nozzle delivers powerful, rotating jets that blast away dirt and grime effortlessly. It’s rated for up to 3000 PSI, and it really shows in the performance—cleaning tasks that used to take much longer are now done in a fraction of the time.I’ve used it on everything from driveways to patios, and the results have been fantastic. The rotating action is great for getting rid of stubborn stains, and it’s a huge time-saver. The nozzle is well-built and feels durable, and I haven’t had any issues with it at all.
Moses Isaac
2025-08-04 17:48:10
Works as advertised, good buy.
Brent Dennard
2025-07-07 11:47:35
Even though it's "alu-minimum" it works with my 3200PSI stihl washer, and surprisingly works well with my electric 1200(~800 actual PSI) washer. It definitley doesn't work as well @800Pissys, doesn't spin as fast but it works and has been working for two years or so now, I'm impressed for the price. The stihl version of the same thing is not reliable at all, I had to trade it out at Ace Hardware 3 times, and they charge $45!!!
john marshall
2025-07-05 10:31:25
Use this unit on painted concrete for a water fountain in the backyard. It took the paint down to the concrete in most areas. Very powerful unit.
Jack T. Walker
2025-07-01 21:36:12
Ordered in December 2023 but never used it until 7/21/24.The pressure washer attachment worked great for 20 minutes. It pulsed as it should and then became a steady stream. The "manual" that came with it is a complete waste of paper and ink. It says to clean the orifice but there is NOT a single word, picture or illustration on how to take the thing apart to clean it. The brief "manual" spends more effort describing how great the manufacturers customer support is than anything else. If I shake it the internals move around but when reconnected to my 2500psi washer it tries to pulse for less than a second then goes to a steady stream. I did find a diagram from another website that has an exploded diagram of the thing. I will try to disassemble it and figure out what is wrong. It doesn't work now so only out $14.06 and know not to buy another one.
PKS
2025-06-30 15:04:55
I bought this thing before a lot of the electric power washers came with them now. They got wise to the fact it REALLY WORKS I guess :) I was skeptical that it would do much ,but man it has proven to be a great. It really ramps up the effectiveness of my cheap HF 1500 PSI electric power washer. Mind you I had to swap out the cheap hose and handle that comes with it, but that's a normal upgrade for most HF units. I used this nozzle to clean 40ft of 5ft wide sidewalks, my 10x20 parking pad and a similar sized back patio. It took a bit, and you gotta have some patience but it removed years of grime, algae, dirt, and stains off the concrete. If uses a ball bearing it appears, so the spray pattern is round so you'll have to go over the surface a couple times to get a uniform look, but WAY cheaper than a surface cleaner attachment for the pressure washer. Cleaning concrete is so therapeutic :)
ChopDunkSplit
2025-06-27 16:57:10
UPDATED Review: (7/14/2023)Bought this for a 2300psi Pressure Washer. Straight out the box I put the correct quick connect on the tip using pipe thread tape. Installed it onto my pressure washer which is a brand new 2300psi Greenworks, prime it up, power on, and begin to wash my front porch. FAILURE instantly as the tip will not spin as these Turbo Heads are meant to do. So begins the troubleshooting, after several different attempts the only way I got it to work is adding oil lubrication into the turbo tips quick connect orifice. Let the lube creep through then try pressure washing again. Still, even after the lube, no immediate spin action. You have to beat the head against something hard in order to initiate the spin. FINALLY.. it works.... for every bit of 20 seconds until the water has flushed out all the lube, then as you guessed, stops spinning again. At this point, I removed the tip from my pressure washer, summoned my inner Kobe, and swished an inferno of a drum canister fire I had going a few yards away, and there.... it met it's fate.**Revision: Well it was a trash drum for burning trash, that had not quite yet been lit on fire yet but was in its eminent future. So after cooling off from the frustration I did dig it back out of trash to give it another chance. So now after constant abuse of hitting it on something hard to start the spinning of the head. It somewhat works decently now. I originally gave it a ★☆☆☆☆ but upgraded that to a ★★★☆☆ due to its still requiring to be banged against something in order to initiate the spinning. However, where it would stop spinning under pressure during mid-use, at least now it keeps spinning until the trigger if released. That needed bang against something to start spinning though, its a mustnevery time you hit the trigger.
Josh S
2025-06-18 19:31:45
This tip is powerful can eat through wood took the stains out of concrete in seconds
Sandro Piscopiello
2025-06-17 11:06:41
Ok
MisterMike
2025-06-01 15:16:22
I have a Ryobi electric pressure washer (model RY14122) rated at 1700 psi and 1.2 GPM. This nozzle simply works great with it, no problem whatsoever.I also like the rubberized body of the nozzle, will help avoid scratching my car. The original nozzle that came with my pressure washer had a hard plastic body and the connector rusted at every use.The connector on this nozzle will not rust, i tried to stick a strong magnet to it just to test if it was ferrous and it would not stick at all. The look of the connector is like stainless steel.I know... some of the pictures might be confusing, but the connector (1/4'') does really look like it's stainless steel, not yellow or golden at all. Maybe it's chrome plated brass ?So far very satisfied with this item.
Miky
2025-03-13 13:31:56
Ugello rotante ha funzionato solo 2 volte . Ritengo che non è un buon prodotto.
Dale (Hamilton)
2024-12-15 10:25:05
Appears to be good quality - Have not used yet - maybe is the spring. Thanks
Enns
2024-11-20 20:34:36
The female threaded end is just slightly oversized - I needed an excess of teflon thread tape to get the nipple end to fit securely in the main unit. It is also tricky to get wrenches on the nuts to tighten the nipple in place, there is not enough room to use a full size open end wrench, a thin wrench is needed.They provide TWO different nipple ends for various types of pressure washers - make sure you select the correct one for your system.
Recommended Products