Your cart is empty.
Your cart is empty.Be sure to measure carefully for a correct fit. Diameter of hole 1/4" and thickness of panel 1/16" If measurements are not correct this bumper will not fit. Bumper Diameter 1/2" --- Height of Bumper 1/4" --- Stem Fits Hole Diameter 1/4" --- Ridge Diameter 5/16" --- Optimum panel thickness 1/16" ---- Hard abrasion resistant SBR Rubber --- Durometer Hardness is 55A to 65A --- Temperature range of –25° to +180° F.
Paul W. Guindon
2025-08-21 18:17:40
This is a tight fit but will not fall out like the original one from Blackstone. I have a 36 inch model 1932 griddle. These are just a bit wider and taller than the original Blackstone bumper but the increased height causes no lid closing issue as the left bumper is still the original Blackstone bumper. Just use a small regular screwdriver to compress it and rotate it into place. I have not cooked on the griddle yet so I am not sure how heat resistant it will be but I will update this review after a few cooks. I give this four stars until I cook and see if it does not melt.Update: Upgraded to 5 stars. I have cooked three times with heat in the low position but Blackstone owners that at low a griddle still gets quite hot. I did one high heat after a cook and cleaning and there is no indication that the rubber bumper is breaking down from heat. So far so good. I would recommend this item to replace the Blackstone original rubber bumpers for the lid.
BR Peace
2025-08-08 20:06:22
Installed easily. Did the job as advertised.
old and in the way
2025-06-18 10:01:58
Fit perfectly on our Arctic Fox stove cover. 2015 Four stars because of price, but worth it when needed.
Value Buyer
2025-06-16 14:54:51
Perfect fit and quality material.Even though the profiles of the original foot (bumper) and this product are dramatically different (see photo) this replacement product fits perfectly in the Crock Pot 1/4" insert hole and stays snug and secure. The two critical dimensions are the diameter of the stem and the diameter of the "mushroom" base. This mushroom base diameter is the same as the original product (see photo).I searched extensively for a OEM replacement product with the exact dimension of the original on Amazon - none exist. Amazon has one product that is very similar to the original profile but the dimension of the section that holds the foot in place is too small and eventually falls out per one of the reviewers.I found a product that appears to be be an OEM on another e-commerce site. However the unit price (per each) was much higher than what I paid for the reviewed product that came with multiple pieces. The seller also wanted shipping costs.
Brenda
2025-05-08 14:26:25
delivered as expected
YKK
2025-03-13 14:03:44
I bought this to replace a missing rubber bumper on a Weber bbq. Nothing exotic, they don’t get hot (just a support for the aux burner lid). Weber sells them - for $5 plus $10 shipping! And that’s for quantity one. Nah… these aren’t identical but plenty close enough, fits fine and works fine.
Flag Girl
2025-01-10 18:41:02
These are so hard that you can’t get them pushed in.
JBH
2024-12-31 14:01:45
The support legs on th bottom of my olf crock part hadmelted and no loonger protectin what it was sitting on. These new replacement legs fit perfectly and were just what I needed.
Recommended Products
$48.50
$ 21 .99 $21.99