Your cart is empty.
Your cart is empty.Product Description
Fitment:
Universal fit for 8MM hole, they'll work with most popular motorcycles such as sport bikes / street bike /off road / chopper / cruiser / quad / dirt bike
Two Installation Methods:
First One: If the diameter of your original turn signal light mounting bolts is 8mm, just take off the tock light and install the new light
Second one: Install the new light on anywhere you want to mount. What you need to do is to drill 8mm hole and then mount the new turn signal on the hole
Specification:
LED Lights Color: Sequential Amber
Voltage: DC 12V
Cable Length: 28cm/11inch
Material: Plastic + Metal
Position: front / rear
Package Including:
4 x Flowing Amber Motorcycle Turn Signals
Feature:
Universal fit
Water sealed, IP67 waterproof
Easy installation, bolt mounting
Connection: black wire - negative; yellow - turn signals
Notification
1. If the lights stay solid, don't blink, you may need replace your factory flasher relays with led relay
2. If the lights get hyper flash, recommend using a resistor to solve the issues
- Diameter of Mouting Bolt: approx. 8mm / 0.31inch
- Thread Length: approx. 2.2cm / 0.72inch
Sequential Amber Lights
The amber turn signal lights illuminate from one side to another side sequentially and flash like water flowing, very distinctive.
Waterproof
Well-sealed on the edge, effectively keep water out of housing, stay illuminated in rainy days
Universal Compatibility
The turn signal lights with 8mm mounting bolts can be used on most motorcycle
Thread Length: approx. 2.2cm / 0.72inch
High Quality Smoked Lens
Made of high quality pc lens and ABS housing
durable and anti-scratch
28cm/11inch Wire Length
The wire is long enough to run it to your turn signal harness
2 Wire Connection
Black wire to negative
Yellow wire to negative
Elizabeth
2025-08-25 15:57:41
Not much to say other than these work very well. I especially like the sequential movement of the LEDs (even though there are only 3 LED elements per signal - they are quite bright and the directionality of the sequence is very clear).Installation is simple - and the bases for these are actually very nice as they grip to the mounting surface well if you don't use the metal piece and mount plastic to plastic.No-brainer purchase.
Rachael
2025-08-17 10:25:07
they work nicely so far, not super bright, but they get the job done, I recommend loctite or a locking washer on the stud to prevent nut from backing off, wires are kind of small and thin, but work alright
Shan aka:Saltygirl
2025-08-16 11:16:24
Great little signals, work perfectly! Great value considering some of the others on the market. They aren't too big, yet they are bright and visible.
jmason90
2025-08-01 14:13:09
Fit great and looks sharp on my Daytona. Install was easy and they work great!
passerby
2025-07-21 20:14:10
First set I bought, two of the signals were defective. One was cloudy, and the other badly scratched. I assume they sent a set that was previously returned. Seller would not replace, but offered a partial refund. I got a second set and it's ok. I will say, they're not very bright, but they do work and look decent. If you need bright light, look somewhere else.
Michelle Kraese
2025-07-13 11:05:02
installation is easy and they are bright and function well when first installed, but I had them on barely two weeks and 3 out of 4 immediately got condensation and now the LED is not working properly, the lights turned orange and only orange, also both rear blinkers broke within the first week, they snapped off the housing, the plastic broke right from the bolt, when working properly and no condensation there nice lights, but unfortunately there damaged, and the bike was barely ridden. This is the second set I bought bc the first set broke during transportation but this time they just broke, and I also put clear glue on the first set to seal the lights, I didn’t do that this time but I didn’t think I had to
Not what is shown in the pictures
2025-06-14 21:12:26
Have had on my bike for a few months now without any problems, dropped bike on then and just a tiny scratch no cracking or malfunction
Paul
2025-06-10 15:33:18
One of the LED boards came loose in one of the blinkers. Had mounted for about 1 month. Reached out to the seller/manufacturer for warranty and have had no response. Only way to contact is through Amazon. Nice looking, not super bright. The sequential blink was a little faster than expected. I will have to replace all 4 with a different set.
Clay
2025-04-30 13:35:50
I’ve bought a few different turn signals from Amazon and these are by far the best bang for your buck. Hopefully they last awhile. Just wish the base was more of a rubber material as it’s hard plastic so there is no flexibility but they are nice and bright.
CRForlife
2025-04-23 17:11:10
These installed in place of OEM lights on my 1983 Honda Magna. Great look and budget pricing.
Mont
2025-04-09 11:26:39
Likes are well built and look nice. Unfortunately not bright enough for street use.
Derek
2025-01-14 13:52:47
These work great and were simple to install with basic hand tools, nice and bright as well.
Oscar David Moras Morales
2025-01-04 12:54:54
Son un tanto pequeñas, el tornillo que las sujeta, no llegaba a agarrar la tuerca, tuve que quitar la base que tiene, para que las pudiera fijar. Fue mi error no checar las medidas a detalle, hasta el momento funcionan bien, los cables que traen son un poco delgados, pero de largo están bien
Recommended Products