Your cart is empty.
Your cart is empty.Product Description
Increase efficiency and effectiveness
These electrical quick-connectors make it easier and faster to wire up electrical boxes and junction boxes. For use with solid wire only.
tl_1197
2025-08-21 17:45:37
Better than the wire nuts, it holds the wires tight
Eric K.
2025-08-17 09:16:59
These are quick and easy to use. The biggest downside is needing to cut them off if you make a change.
Jeffrey
2025-07-04 12:48:00
These are awesome
Batboss
2025-06-23 17:00:13
I use these all the time now...very handy and secure...and these were priced much lower than the few I was able to find locally.
B
2025-03-04 12:42:43
I returned this item because it was bought by mistake. However this is a great product. I only returned then because I thought it e was set screw when I bought them and it was the snap together which I already had three hundred of. All in all I recommend this product and will buy again when I run low
Carol
2025-02-19 16:10:14
These made replacing light switches so easy! They don't take up as much space as a wire nut, and it's easy to see that the wires are seated in the connectors.
william extein
2025-02-05 09:57:00
Many were damaged it appears I got factory seconds
Will1918
2024-12-25 14:39:20
These push-in electrical connectors are much more convenient to use than wire nuts. The stainless steel inside the connector applies a good amount of pressure to make a firm mechanical and electrical connection independently for each of the 3 wire ports. Notice the 3 different levels of deflection in the stainless steel in the picture. Unlike wire nuts, push-in electrical connectors are not designed to be reused.As the listing states that the Harrier connectors are UL listed, I was surprised that the listing did not also state a current rating. It only states voltage ratings of 600 V max building wiring / 1000 V Max fixtures and signs. Looking at the markings on the connectors simply added to the confusion. The following markings are found on the connectors:2.5 450v 24AUL US 600v20A 300vI’m still not sure what current these connectors are rated for but I did look at the contact area between wire and stainless steel connector, and it’s very slight. There is certainly less contact area than I'm comfortable with for a 20A circuit using 12 AWG wire. I’ll be using these Harrier push-in connectors for low current applications unless or until I can get more information from the manufacturer.I rated the Harrier connectors 4 stars as I’m not sure what current I can put through them safely.
Recommended Products