Your cart is empty.
Your cart is empty.David N. Andrew
August 21, 2025
Worked with hydraulic flush tool I made
kylejhill
July 30, 2025
Bought these to allow excess crank pressure out of my crank case while also keeping any vacuum for necessary operation. So far I’ve only started the bike and let it run but have not gone for a ride, but it seems to be working as intended.
RickyBoy
July 16, 2025
Item was properly sized for a 3/8 inch hose. On the downside, it requires quite a lot of pressure to open the one way valve. On the plus side, there is virtually NO back flow after pump shuts off. Definitely, not for use in any situation that requires a gravity fed flow.
Ccfab
June 14, 2025
I’m running 30HG through these and they have held up nicely.
World Traveler
May 18, 2025
The check valve on my HVAC condensate pump stopped working. This caused the pump to loss efficiency and run more often. I purchased these so water would stop flowing back into the condensate pump. I tried both valves, facing correct direction, and neither of them worked. The water still flows back into the pump. I'm going to try another brand.
Customer
May 6, 2025
Intended to use this to prevent siphoning, but the valve won't open with the small water column behind it. Might be good for usage with pumps, but not for what I needed it to do.
Steven and Bambi Linker
April 13, 2025
Worked
WLS
April 1, 2025
These units worked well to stop backflow and siphoning in my RV water system. I would recommend these if you have water pump cycling due to air loss or pressure loss.
George Galvin
March 18, 2025
Were smaller than anticipated, but could be also slightly difference in pipe size
Debra Carey
March 2, 2025
Great little valve
Serge picard
February 12, 2025
Bateaux
KMGingeri
February 11, 2025
Check out my picture. The hours is 3/8" ID (see labelling on hoes). Compare to labelling of the package these came in and the one connected to the hoes. 🤨
Reviewed in Canada
January 31, 2025
Worked perfectly for my purpose. Only problem is that it's not marked which direction it should flow and a check valve only works one way. I just blew through each opening to figure out which direction would prevent air from going through before installing it.
Recommended Products