Shopping Cart

Your cart is empty.

Your cart is empty.

RadioMaster 2.4GHz RP1 ELRS FPV Receiver ExpressLRS Nano Receiver Come with 65mm UFL T Antenna for TX16S TX12 Zorro ELRS RC Transmitter

Free shipping on orders over $29.99

$19.99

$ 9 .99 $9.99

In Stock
  • RP1 2.4GHz ELRS Nano receiver is an open source receiver based on ExpressLRS with ESP8285 MCU and SX1280 RF chip.
  • The RP1 has a UFL antenna socket for a full range of antennas, is ultra light weight and small in size, making it ideal for racing.
  • The RP1 has built-in WIFI, so you can upgrade the firmware via WIFI and configure the receiver with your PC or cell phone via the built-in WebUI.
  • With its low latency and high refresh rate RF modules, the RP1 is ideal for FPV racing or long range.
  • Suitable for Whoops, drones and fixed wing models, these receivers can be placed almost anywhere due to their ultra-light and Nano size.



Product Description

1

  • Bullet Point:
  • Improved PCB design is better for heat dissipation.
  • Upgraded rigid antenna with greater durability and performance.
  • LED on the top side of PCB.
  • Solder pads are improved and easier to solder to.
1

  • Specification:
  • Item: RP1 Nano ExpressLRS 2.4ghz Receiver
  • Type: ISM
  • Antenna: 65mm 2.4ghz T Antenna
  • Maximum receive refresh rate: 500Hz / F1000Hz
  • Minimum receiver refresh rate: 25Hz
  • Working voltage: 5v
  • Weight: 2.2g (Including antenna)
  • Dimension: 13mm*11mm*3mm
  • Firmware Version: ExpressLRS v3 pre-installed
  • FW Target: RadioMaster RP1/2 2400 RX
  • Bus interface: CRSF
1

  • Package Includes:
  • 1 * RP1 ExpressLRS 2.4ghz Nano Receiver
  • 1 * 65mm UFL 2.4Ghz T Antenna
  • 1 * User Manual

SgtKickAzzTTv
2025-08-11 10:16:22
Works as described...
Chris nunan
2025-07-01 16:27:08
Radiomaster quality. One of my go to flr ease, size and price.
Z. Weinley
2025-05-15 17:38:03
Great value for money, wide selection of big and small. Wet easy to use and fast working. The picture look and range just as it did before applied to skin.
Shawn
2025-04-16 12:45:18
Ep1 and ep2 this size are good for small quads and even tho they are better then other receiver types when it comes to link, I would not use them for actual long range. I’m mostly saying this for noobs. Yes it’s a great little receiver. But no It doesn’t compare to ep3 with diversity. If you want your 3” to fly “far” it’s all good your battery shouldn’t let you get far enough out for the link to drop low, If you want a 5”-7” to fly far get the ep3 with diversity or better. And be careful. If you bend the antenna connection to abruptly you will most likely break the connector off. Then you either have a useless receiver or you better learn to solder on new ones and they are tiny. I use ep1-2 on builds that have no room for anything else or no antenna clearance.
Jeanne Battaglia
2025-04-06 12:35:52
👍🏼👍🏼
michael
2025-03-31 10:14:10
Works well
JMC
2025-02-21 16:58:34
No issues whatsoever. Came updated with v3.0 ELRS so I didn't have to flash, just had to put my keyword in and it bound to my TX16S's ELRS module. Works just as well as any other ELRS Rx's I've used but with a good price for next-day delivery.
D.V
2025-01-21 13:52:13
Radiomaster makes one of the best elrs modules in my opinion.I have tried a few name brands and all work but for some reason all my Radiomaster RX seem to work the best meaning best connection,I always set my Transmitter on dynamic,so if I'm close it automatically chooses the right strength,with these Rx modules it will stay on the lowest power even when I get far,it doesn't automatically go up to full power because it doesn't need it in open space but still works as good behind trees or buildings.I LOVE these and will start to buy only Radiomaster from now on.
Recommended Products