Your cart is empty.
Your cart is empty.This is a new spring compressor tool for use in GM model transmissions for removal of the low/reverse rear case clutch piston. The tool for use on GM 250, 250-C, 350, 350-C, 4T80-E,700-R4(4L60E) (4L65E) (4L70E) (4L70).
Matt
2025-09-04 16:27:33
Cheap, had to fiddle a bit to get it just right for my th350. But for the price and the speed that it arrived, I cannot complain!
Customer
2025-08-26 11:59:18
Not something I would suggest for a professional but for an occasional use, the price is good. A little "notchy" feeling not really smooth but got the job done.
Phraust
2025-07-14 10:59:07
Where the threads meet the u-channel, the washer they welded to the end is very poorly tacked in only 2 places and was incredibly thin, which broke off immediately when slight pressure was applied to it. It was also welded on at an extreme angle, making it impossible to use this tool for its intended purpose. Its very clear this company is trying to be as cheap as humanly possible, and does not implement any semblance of quality control in their products, and boy does it show.Don't buy this product, it is a waste of money.
ADAM
2025-05-15 15:38:39
Tight fit, however worked as needed.
Brandi Christian
2025-05-10 18:51:03
bad welds , welded together crooked
Vernon W.
2025-04-26 13:34:24
The tool worked for what it was made for.
network Engineer
2025-04-17 12:56:46
Too weak, fell apart on the first use!
Kirk L.
2025-02-14 16:28:31
Ended up using my homemade tool,it's in the way of removing and installing the clip
Recommended Products
$98.99
$ 45 .99 $45.99