Your cart is empty.
Your cart is empty.
Product Description
Use as a replacement part on Full Facepieces 6000 Series.
From the Manufacturer
The Lens Assembly 6898/37006 (AAD), Respiratory Protection Replacement Part is designed for use with the Full Facepiece 6000 Series (sold separately). This lens assembly consists of a hard-coated polycarbonate lens with installed bayonet attachment inhalation port fittings, inhalation valves and inhalation port filter/cartridge gaskets. Using this replacement part can extend the service life of respiratory protection equipment and potentially result in cost savings.
Mckay
2025-09-02 15:50:22
Fit great. I didn’t realize how much i couldn’t see with my old scratched up one. I recommend buying the film protectors to put on the mask to prevent scratches
Gary Mitchell
2025-07-05 15:13:56
Replaced original scratched up visor. Great fit
Jim Kringlen
2025-06-12 18:07:46
i have bought alot of these. they were of better quality when first purchases.the last few batches i have had trouble with nose piece fitting properly. i had to sand and file to make them work and the plastic feel different, lighter and less celerity. they are not 3M.They still work, and the price is good.
David Ray
2025-05-13 10:03:44
Easy install with a Phillips screwdriver to disassemble the frame on my 6800 mask. After that, everything is snap and twist. It took longer to wash and dry the rubber face pieces than to install the replacement lens. I checked the seal after replacement and the assembly was airtight and good as new.I had no issues with the product quality- I have been using the branded masks for decades, and I would not hesitate to recommend this lens replacement.
Project Manager
2025-04-17 20:29:49
The moment I attached the 3m Filter cartridges the lugs broke, rendering the replacement useless. Not on one but on both replacement lenses I bought from Amazon.
GC
2025-03-17 14:08:49
Nice to bring life to something that’s sat awhile. Now my old mask can be a spare to leave in the shop or truck. Only gripe is I had to break a plastic tab off to be able to properly rotate the exhale valve onto the new shield. Otherwise it’s a quick job with just a Phillips screwdriver. I’d advise having something handy to clean the old mask parts as you go. Good opportunity to really get in there when it’s all an apart. Would recommend this for someone with an old mask as scratched as mine!
Troy Queen
2025-01-24 09:33:55
It was what they said it was
Evan
2025-01-22 15:01:39
For being a part of personal protective equipment, the final product quality is very low. Where the filter cartridges connect, there are bubbles around the lugs creating weak points. They’re not just in the product but actually bubbled to the surface allowing air/ gas to transfer from one end to the other without filtration. Even with using proper gaskets, they make the mask completely useless. I effectively have an expensive face shield. Would not buy again.
Recommended Products
$79.99
$ 36 .99 $36.99
$19.30
$ 9 .99 $9.99
$234.50
$ 99 .00 $99.00