Your cart is empty.
Your cart is empty.Product Description
Q: Can UV resin and ring fixators be reused?
A: The UV resin we provide has sufficient capacity for more than 30 times of use. In addition, the ring fixator can be reused. There are multiple ring fixators in the product box, so there is no need to worry about insufficient quantity.
Q: What are the most crucial operation tips to be informed of?
A: As shown in the picture, the UV resin dropped into the ring fixator needs to be higher than the horizontal line. In this way, the presented effect is perfect.
Q: The operation seems not complicated, but what if I'm worried that I can't learn it?
A: The operation is very simple. We have also prepared a test ring for learning and use.
Jessica S.
2025-08-05 16:49:32
The media could not be loaded.
DoubleEll
2025-07-06 13:17:46
This is such a cool product. Pretty easy to use and seems to hold up well. My only complaint is that the edges are a little sharp, probably because I didn't follow the directions and mound it up a bit inside the foam holder. It definitely takes a little practice, and they give you a practice ring, which is nice. I will need to remove the hardened gel when the weather gets warmer and I don't know how that's going to go, but they say you can just run it under hot water and peel it off. Overall very happy with this product.
Avid Reader
2025-06-09 11:31:46
This product is difficult to use esp. for thicker ring bands. The resin came right off the ring, and sides where the ring is below the foam form is rough. I tried it twice on two different rings. Disappointing.
Alissa
2025-02-07 10:10:27
This is a great idea but not the easiest to use. I followed the instructions and applied it to a couple of thin banded rings. It was a little hard to get the proper size and the edges were sharp after curing. I had to use a nail file to smooth the edge out. The adhesive material on one ring fell off later that day. Will try again to see if it’s easier to use with a thicker ring.
Jillian Kieda
2025-01-27 10:11:58
Ive been losing weight and i know that frequent resizing of rings can compromise the integrity of the metal of rings, so instead of resizing it down constantly, i opted for a temporary solution.The squeeze bottle has a twist off lid, and the foam holders work really well, it is a little hard to figure out how deep the ring should be set up prior to the uv resin application- the first swing I over-tightened the ring. I put some boiled water in a thermos and let the ring sit for about 15 minutes, this was enough time to make the uv resin pliable and easy to remove.The second go around was much better, I flipped my ring upside down so the stones were on the bottom and used that as a way to figure out how deep i needed to set my ring up.Second go around, my ring fits perfectly and I'm no longer worried about flinging it off. Only time will tell how long it will last, but I generally remove my jewelry when dealing with water in any capacity.Definitely better than the coils and it doesnt cause my sensory problems like the coils.The bottle of UV resin is enough to resize rings a good amount of times.If you decide to order this, do NOT snip the cap on the bottle, the top twists off and you can re-cap it.
Kel
2025-01-13 20:39:20
Exactly what I was looking for. Easy to use and comfortable.
Gary From Chicago
2024-12-20 15:05:10
Some of the reviews are not so positive and in my opinion, they didn't follow the instructions well. I read what it had to say, but I want to add, make sure your ring is clean. After a weight loss my wedding ring was too large. I carefully followed the instructions and the product worked great. The ring doesn't fall off, you can't even see the product on the inside of the ring. It's been over 6 weeks and all is well. I am glad I bought it.
G. Oakenshield
2024-11-12 18:49:47
Simple and easy to use - was super helpful to comfortable fit a ring that could not be resized by a jeweler.
Recommended Products