Your cart is empty.
Your cart is empty. Name: Screw Terminal Block
Material: Brass, ABS
Model: JX5-6004
Rated Voltage (Max.): 500V
Rated Current (Max.): 60A
Poles: 4 Positions (Dual Row)
Dimension: 69 x 32 x 26mm/2.71 x 1.26 x 1.02 inches.
Package Content:
1 x 4 Position Double Row Terminal Block Strip.
Rusty Ulmer
2025-09-06 21:00:48
Worked Great
monolith177
2025-06-28 18:00:56
This is the exact product I needed to splice 6/3 NMB wire to 6 AWG THHN wires to run through EMT conduit! The negative reviews are a bit harsh, but have points to consider… the listing should say this is for #6 wire (probably not for #4), and yes the brass terminals are thin where the tapped holes go through.Only tighten the screws as necessary to connect the wires. Learn from the other reviewer who cracked the brass terminals during tightening.The Bakelite phenolic case is thoughtfully designed to conceal all connections from each other and from the junction box. The case seems quite sturdy.As another reviewer showed, ganging two 4†x 4†electrical work boxes together provides a nice amount of space to get these stiff wires where they need to go.The ground wire in 6/3 NMB cable is thinner than #6 AWG. The terminal can easily accommodate the ground wire and an equal gauge pigtail to connect to the box ground (this is not the case on the #6 THHN side of the terminal… only one wire will fit).Hopefully my review will be as helpful to someone as the other positive and negative reviews were to me!
J in Cali
2025-05-02 14:41:14
I needed to replace a terminal block that had burned out due to a loose contact in a 2000w/240vac space heater. This was a good choice. It fit properly in the old unit and handled the 12g stranded wire. I sweat soldered the ends of the wire and then inserted them into the block. The screws tightened securely down onto the wire using a Phillips driver. Mounting the block was easy with a couple of 8/32 bolts.
Mary
2025-04-28 18:44:45
Worked as I expected, no issues.
Lance Dammeyer
2025-02-07 10:51:02
Product was well built and fulfilled my need to splice/terminate a 50 AMP 8AWG power cable from generator to APS. Highly recommend.Would be great if a clear plastic cover could be installed.
Randy
2025-01-28 16:33:07
Works great for what it is made for
Gary T. Schultz
2025-01-22 14:38:27
Built more solid than expected. Works perfect with 6/3 NM cable. Patience needed when installing wires into brass connectors, as the 6 gauge wires barely fit. I would not expect this to work with 4 gauge wire. If you need something for 4 gauge wire, do not buy this.
Francisco Brum Jr.
2025-01-01 13:34:52
A+
Recommended Products
