Your cart is empty.
Your cart is empty.Product Description
RVZONE Round Dot Lighted Rocker Toggle Switch Panel
1.High Quality: The rocker toggle switch panel is made of high-quality aluminum plate and ABS material, which is durable and waterproof
2.Protection Circuit: output circuit protection, reverse polarity protection，and overload protection.
3.Installation Scope: Suitable for high-end large transportation tools such as ships, yachts, RVs, buses, etc
4.Product Usage: It can be used as a headlight switch, fog light switch, width lamp switch, car refrigerator switch, car vacuum cleaner switch, car external equipment power supply, and for power supply of mobile phones, tablets, etc
mike rudy
2025-07-06 14:37:02
Easy to install, nice looking, worked to perfection in Club Car gas cart.
jwc1926
2025-07-03 11:24:37
I got the three-switch version. The plate is nice. Not cheap plastic. I had to drill out the holes a bit, and there were strands of aluminum coming off the bit. The wiring is simple, but nowhere explained. Use a 16-22 gauge female spade connector to connect the positive lead of your device to the MIDDLE connector on the switch. (The seller says you don’t use it, which is just wrong.) Use some kind of 16-22 gauge connector (e.g., a butt connector) to connect the red wire that will attach to the positive terminal of your battery to the red pig tail wire coming off the switch. The wiring on the switch appears to be 16 gauge (16 AWG), even though the switch says it’s rated for 20 amps, so I wouldn’t load the switch (or switches if you have the three switch version) with more than 13 amps total. Next, strip about a half inch off the end of the black wire coming from your device as well as the black wire that will connect to the negative terminal of your battery. Then twist the ends of these wires together along with the black wire coming off the switch and secure them with a wire nut. Wrap with electrical tape to make sure the wire nut doesn’t come off. Now connect wires to the battery. Don’t forget to splice in inline fuses of appropriate amperage between the switch and your devices if they don’t already have them. That is easy to do with butt connectors. For extra security, secure all connections with shrink tubing and a heat gun. Slide the tubing down the wire before crimping, of course. That’s it.
Torese P.
2025-05-23 09:18:47
At first I thought it wouldn't fit but it fits pretty nice could be a little longer but for the price and the build and the sturdiness it is a hands down win-win for me
Vernon Walker
2025-03-19 15:12:59
Worked perfectly for my small project. The leads were connected on the terminals that illuminate the small blue led on the switch, so I had to figure out how to just get a simple off/on config as I don’t need the blue light. Screws are good quality, as is the switch.
Customer
2025-02-10 10:07:36
Great switch! I used this for my bed lights for my ram 2500 instead of paying hundreds to have them activated with the factory switch which wires weren't ran.
Dylan
2025-02-03 18:51:52
Looks and feels expensive
gelrod
2025-01-19 15:43:42
There are no instructions in box but good ones in their ad. Center pin is hot switched.
R. Bell
2025-01-07 11:45:06
There are many versions out there like this one, it's pretty basic. I like the indicator lights, the back is open and can be wired to your liking: sharing a circuit or separate circuits. Standard 1/4" spade connectors. Having screws in the four corners keeps it no nonsense for when you need to get back in there. Reasonably priced.
Recommended Products