Your cart is empty.
Your cart is empty.From the Manufacturer
If you are a hobbyist that enjoys R/C vehicles or an all out R/C racer or anywhere in between, this tool is a must for your toolbox. Our toe-in gauge allows you to do trackside checks of the toe angles without removing the wheels. Our gauge checks toe through the simple method of comparing the width of the wheels at the rear of the tire to the width of the wheels at the front of the tire. Our gauge is accurate to within one half of a degree per side and closer. This tool can also be used to check legal width of off-road buggies and trucks. The gauge comes with a second thumbscrew hole to check narrower vehicles such as sedans as well.
CavGeek
2025-09-03 11:16:42
Easy to use, great instructions, takes the guesswork out of setting toe in.
Joe C. Wells
2025-08-04 15:12:14
Good instructions. You will need them. Works well after you get hang of tool.
HerkDoctor
2025-07-06 15:54:04
Kind of a pain to use, needs some fiddling but does the job.
SHARIF FAJARDO
2025-05-16 09:23:22
Works fine with my trucks. Gives precise toe degrees
Mope
2025-02-27 16:45:35
Not the easiest to use but comes with instructions. I used this twice now as I have a set of street tires and off road tires for my stampede 4x4. This will get you higher speeds and better control and better tire wear if aligned properly. This is useful but I think the camber gauge is little better investment since this only does the front tires of the stampede as the toe is locked
Amanda Fannin
2025-02-16 17:20:14
Was a little difficult to figure out only because I am new to the rc hobby. But once I watch a video to see how you set it up. It’s became very straight forward. Extremely helpful and a must have tool in your rc car tool box
GlennS
2025-02-08 10:43:23
I think it was a great concept but for me it has been difficult to use effectively. Although it is one of the few toe-in gauges I have found it sits unused taking up space in my toolbox. I set my toe-in by sighting the edges of set-up wheels to the rear wheels, this is the best method I have found thus far.It is well-made of durable plastic as I have came to expect from RPM.It would be good to check for width limits at a Race vehicle inspection, but in my experience this is about the limit of its usefulness-hence the 3 star rating. I cannot recommend this for setting toe-in.
Steve Mongone
2024-12-23 10:12:05
I haven't use it much as my front ends are pretty loose, but it does help. Good quality from RPM
Recommended Products
