Your cart is empty.
Your cart is empty.Product Description
Package Includes
- 12 Pcs of Cutting Board Feet 13/16" W x 3/8" H
- 12 Pcs of 304 Stainless Steel Screws #8 x 5/8"
Multipurpose Rubber Feet for Cutting Board, Furniture, Small Electronics.
Non-Slip Bumper Feet, Protect Surfaces From Scratches.
Not too soft nor not too hard, non-slip. Perfect for use as cutting board feet, chopping board feet, carving board feet, rubber furniture feet, rubber table feet, rubber feet for electronics, stoppers for cabinets.
The rubber feet made of high quality silicone rubber material, corrosion resistance. Moderate hardness with good grip and good skid resistance, they don't scratch the countertop, cabinets.
- Material: Rubber
- Base diameter: 11/16 inch
- Top diameter: 13/16 inch
- Height: 3/8 inch
- Hole diameter: 5/32 inch (fits #8 screws)
C & D
August 30, 2025
I almost didn't get these because of the review showing the screw proud of the grommet. Ignore that review. Some people don't try, some people don't know; they managed to put zero effort into both. I would of saved 15 minutes if that review didn't exist. I just kept on looking; last time I take advice from an idiot. 3/8" thread depth, 1/2" if you over do it, I pre-drilled 1/16". If they fail it's on you. You overtightened, pre-drilled oversized or exposed it to lateral stresses.Some products suck, this one is fine.The people are broken; disturbingly broken.
Michael Judd
June 24, 2025
The rubber feet keep my hand crafted cutting boards from sliding on my cupboard.
Stefani
June 20, 2025
Great for my cutting board
Eric
April 24, 2025
The rubber is hard (almost like plastic) and does not grip as I would have like it to. I am using under a fairly thick piece of wood butcher block and it does slip when pressure is applied at an oblique angle. It likely depends on the surface beneath as I would imagine granite or glass yields better grip but it doesn’t work great for me. Otherwise, a nice product.
Scott McLean
April 18, 2025
I have a large cutting board I received. It had cheap rubber stick on feet. These did not raise the board off the potentially wet surface. These keep the board off the surface ensuring the board remains off the potentially wet surface. I but pricey but well worth the functionality.
Jimmy Jowers
April 11, 2025
The rubber feet are quality, the stainless steel inserts and screws are vital for the cutting boards.
Diane Beitz
March 26, 2025
Arrived when we were told they would be. Work great on 2 boards.
Richie
February 14, 2025
Revolutionary. My huge wood cuffing board would run and spin and the slightest touch. No cut was safe from unanticipated spin. The feet ended it all. It is locked down? Glued? Super imposed? Connected on the quantum realm?? No, but it doesn’t slide anymore and that’s nice.
Recommended Products