The media could not be loaded.

It makes a very noticeable difference in the brightness of my break/ turn signal lights, no hyper flash at all, just plug in and go like the original halogen bulbs. They make a very faint noise from the fan while on but it’s hardly noticeable when the car is off and you can’t hear it at all with the car running. One of the lights on the right side of my car makes an ever so slightly louder noise from the cooling fan and vibrates the tail light just a little more when you touch it but they are working great so far! Will update if anything changes but they are great so far and are a huge improvement from the stock bulbs as the picture shows! I also replaced my back up light with a bulb from the sealight and that was the same experience plug and play and much brighter than stock

Very bright ! Works great

I had originally bought Sylvania LED bulbs to replace a bad rear turn signal. I immediately got the hyper flash. Looked for other LEDs that would solve the problem and even tried Forscan (got a cheap adapter that wouldn't work). I've used Sealight bulbs in the past and have had no problems. They worked great from the start and they still do.These bulbs solved the hyper flash and are super bright and easy to install. You get what you pay for, but it's nice to save a few bucks without having to sacrifice quality with these.I've seen 'anti hyper flash' bulbs for $60-$80 a pair. These were a lot less expensive and work just as they should. I only wish I could get these in my local parts stores since there are at least three of them within a couple miles of home.

PROS: Very bright; direct replacement for factory bulb. Did NOT cause hyper flashing.CON: VERY loud cooling fan - you can hear it with the engine running; was upgrading a 2005 Buick LeSabre and it made the cruise control stop working. Had to put original halogen bulbs back.

Well made easy installation from weak yellow light to much brighter white light, extreme improvement for. Night.

I had previously purchased Sealight bulbs for our Toyota Highlander and installed and had them worked without issue. I thought with this being the case I would be able to the same with these bulbs for our Tacoma that had a burned-out bulb, but that has proved to be anything but simple and possible. Before making a purchase of these bulbs I inquired with the company to ensure correct bulb selection and operation without issue for my vehicle. I was assured these bulbs would work without issue.Once I received them it has been nothing short of a very bad experience. The bulbs themselves do not just plug into and fit into the factory receptacle easily - there are little nubs on both sides of the led base fitting that make it difficult to push in (it should be noted from reading other buyer's product reviews I'm not the only person who has had this happen). Once I got the bulbs installed, they powered on but the same hyper flash from the OEM bulb burn out was still occurring with these new LED bulbs. It took numerous calls and emails to Sealight to reach someone who then asked all kinds of questions but quickly told me they'd ship me a decoder and I could expect to receive it in 3-5 business days. I asked for the decoder product details (picture and "how to" install) and was told they'd email it to me. I never received any email from them. After waiting well over 5 working days, I emailed Sealight twice over three days before I could get a reply. They thanks me for emailing them and stated thanks to my email they had now shipped the decoder (obviously they never even shipped me the decoder from contacting them before). And again I sent them an email asking for decoder product info (picture/install instructions). They never sent anything again.But then today, surprise - the decoder (I'm guessing) showed up. I say I'm guessing because it was not identified as a "decoder" anywhere on the package, product, etc., the package return address was in some person's name and the small package had a ziplock that contained two short wires with 1 set of hollow blue plastic plug looking things and another of the same in red with about 4 or 5 small zip ties. That was it - no instructions were included, no product description or anything letting you know what this was, how to install or use. I tried calling numerous times, leaving a message for a call back numerous times and received no call back. But I also sent an email and got a simple reply which had a very brief 3 sentences/steps on how to. They also ended the email stating "the resistors will emit a lot of heat when working please avoid contact between resistors and other plastics in the assembly." WHAT THE WHAT?!?! This whole thing was largely plastic - blue and red loose hollow plastic looking plugs with plastic coated wires - REALLY?? Avoid plastics in the assembly?? What part is a resistor, how does it wire into with the socket and the bulbs, what do you zip tie to what and how in the world do you "avoid plastic" with such a set up?This whole thing has been totally ridiculous! A simple burned-out bulb that needed to be replaced - I'm not sure what is more nuts - them for conducting business like this to a customer or me for even trying to do business with someone like this. What kind of way is this to treat a customer who is obviously having difficulty with their product and who has tried hard to understand how to best use their product and avoid having ANY issues??From my experience THIS COMPANY AND PRODUCTS ARE REALLY MESSED UP and the LACK OF CUSTOMER SUPPORT AND SERVICE is pathetic and INEXCUSABLE! I'm sorry I ever purchased Sealight bulbs previously and especially now. But I'm very glad that Amazon covers the return as these bulbs as they are being promptly returned. I'M NOT EVER PURCHASING ANY SEALIGHT PRODUCT AGAIN and seriously DO NOT RECOMMEND SEALIGHT PRODUCTS REGARDLESS especially based on the product design, poor customer support and service (think about it, even if their product appears to fit and works and the price might be good, if you ever have any issue with their product, whether at the beginning or later on (like a warranty issue), forget about being able to trust that anyone at Sealight will help take care of it for you). I'm done with this and done with Sealight.I really hope that anyone taking the time to read this will understand and take into serious consideration this information before purchasing any Sealight products!

Installed in a 2014 Ford Police Interceptor Sedan, red, brake light/turn signal combo.Good: Super bright, no hyper flash when headlights are on or off.Bad: The fans are very loud, noticeably loud actually.I returned them and are trying another set of Sealight. My last set was Lasfit but they don’t sell the ones I bought originally anymore. Sealight makes good products and are a trusted brand in my book.

whats the point of an LED than cant be brighter than the halogen it replaces, specially at this price. Would not have bought had known the performance of these. felt wasted in this purchase.both bulbs worked on installation. but quality felt average. Longevity will be reported if any falls short

This solved the hyper flashing on my JK.

Very bright works good . Easy plug and play

Works Great on my 08 Ram 3500, nice and bright.

The product came on time easy to install, less than 5 minutes I recommend these bulbs you'll see the difference when you install them. I just love my car interior brightness

The media could not be loaded.

It makes a very noticeable difference in the brightness of my break/ turn signal lights, no hyper flash at all, just plug in and go like the original halogen bulbs. They make a very faint noise from the fan while on but it’s hardly noticeable when the car is off and you can’t hear it at all with the car running. One of the lights on the right side of my car makes an ever so slightly louder noise from the cooling fan and vibrates the tail light just a little more when you touch it but they are working great so far! Will update if anything changes but they are great so far and are a huge improvement from the stock bulbs as the picture shows! I also replaced my back up light with a bulb from the sealight and that was the same experience plug and play and much brighter than stock

Very bright ! Works great

I had originally bought Sylvania LED bulbs to replace a bad rear turn signal. I immediately got the hyper flash. Looked for other LEDs that would solve the problem and even tried Forscan (got a cheap adapter that wouldn't work). I've used Sealight bulbs in the past and have had no problems. They worked great from the start and they still do.These bulbs solved the hyper flash and are super bright and easy to install. You get what you pay for, but it's nice to save a few bucks without having to sacrifice quality with these.I've seen 'anti hyper flash' bulbs for $60-$80 a pair. These were a lot less expensive and work just as they should. I only wish I could get these in my local parts stores since there are at least three of them within a couple miles of home.

PROS: Very bright; direct replacement for factory bulb. Did NOT cause hyper flashing.CON: VERY loud cooling fan - you can hear it with the engine running; was upgrading a 2005 Buick LeSabre and it made the cruise control stop working. Had to put original halogen bulbs back.

Well made easy installation from weak yellow light to much brighter white light, extreme improvement for. Night.

I had previously purchased Sealight bulbs for our Toyota Highlander and installed and had them worked without issue. I thought with this being the case I would be able to the same with these bulbs for our Tacoma that had a burned-out bulb, but that has proved to be anything but simple and possible. Before making a purchase of these bulbs I inquired with the company to ensure correct bulb selection and operation without issue for my vehicle. I was assured these bulbs would work without issue.Once I received them it has been nothing short of a very bad experience. The bulbs themselves do not just plug into and fit into the factory receptacle easily - there are little nubs on both sides of the led base fitting that make it difficult to push in (it should be noted from reading other buyer's product reviews I'm not the only person who has had this happen). Once I got the bulbs installed, they powered on but the same hyper flash from the OEM bulb burn out was still occurring with these new LED bulbs. It took numerous calls and emails to Sealight to reach someone who then asked all kinds of questions but quickly told me they'd ship me a decoder and I could expect to receive it in 3-5 business days. I asked for the decoder product details (picture and "how to" install) and was told they'd email it to me. I never received any email from them. After waiting well over 5 working days, I emailed Sealight twice over three days before I could get a reply. They thanks me for emailing them and stated thanks to my email they had now shipped the decoder (obviously they never even shipped me the decoder from contacting them before). And again I sent them an email asking for decoder product info (picture/install instructions). They never sent anything again.But then today, surprise - the decoder (I'm guessing) showed up. I say I'm guessing because it was not identified as a "decoder" anywhere on the package, product, etc., the package return address was in some person's name and the small package had a ziplock that contained two short wires with 1 set of hollow blue plastic plug looking things and another of the same in red with about 4 or 5 small zip ties. That was it - no instructions were included, no product description or anything letting you know what this was, how to install or use. I tried calling numerous times, leaving a message for a call back numerous times and received no call back. But I also sent an email and got a simple reply which had a very brief 3 sentences/steps on how to. They also ended the email stating "the resistors will emit a lot of heat when working please avoid contact between resistors and other plastics in the assembly." WHAT THE WHAT?!?! This whole thing was largely plastic - blue and red loose hollow plastic looking plugs with plastic coated wires - REALLY?? Avoid plastics in the assembly?? What part is a resistor, how does it wire into with the socket and the bulbs, what do you zip tie to what and how in the world do you "avoid plastic" with such a set up?This whole thing has been totally ridiculous! A simple burned-out bulb that needed to be replaced - I'm not sure what is more nuts - them for conducting business like this to a customer or me for even trying to do business with someone like this. What kind of way is this to treat a customer who is obviously having difficulty with their product and who has tried hard to understand how to best use their product and avoid having ANY issues??From my experience THIS COMPANY AND PRODUCTS ARE REALLY MESSED UP and the LACK OF CUSTOMER SUPPORT AND SERVICE is pathetic and INEXCUSABLE! I'm sorry I ever purchased Sealight bulbs previously and especially now. But I'm very glad that Amazon covers the return as these bulbs as they are being promptly returned. I'M NOT EVER PURCHASING ANY SEALIGHT PRODUCT AGAIN and seriously DO NOT RECOMMEND SEALIGHT PRODUCTS REGARDLESS especially based on the product design, poor customer support and service (think about it, even if their product appears to fit and works and the price might be good, if you ever have any issue with their product, whether at the beginning or later on (like a warranty issue), forget about being able to trust that anyone at Sealight will help take care of it for you). I'm done with this and done with Sealight.I really hope that anyone taking the time to read this will understand and take into serious consideration this information before purchasing any Sealight products!

Installed in a 2014 Ford Police Interceptor Sedan, red, brake light/turn signal combo.Good: Super bright, no hyper flash when headlights are on or off.Bad: The fans are very loud, noticeably loud actually.I returned them and are trying another set of Sealight. My last set was Lasfit but they don’t sell the ones I bought originally anymore. Sealight makes good products and are a trusted brand in my book.

whats the point of an LED than cant be brighter than the halogen it replaces, specially at this price. Would not have bought had known the performance of these. felt wasted in this purchase.both bulbs worked on installation. but quality felt average. Longevity will be reported if any falls short

This solved the hyper flashing on my JK.

Very bright works good . Easy plug and play

Works Great on my 08 Ram 3500, nice and bright.

The product came on time easy to install, less than 5 minutes I recommend these bulbs you'll see the difference when you install them. I just love my car interior brightness