Your cart is empty.
Your cart is empty.When installing harnesses in your Honda Pioneer you will find that the computer system detects when you’re not wearing your seat belt and will interrupt the ignition to a maximum speed of 15 mph. For safety, this is a great idea when using stock seat belts, but not a good thing when you have installed aftermarket 4 or 5-point harnesses. This seat belt bypass for has been designed to close the open loop system when you install 4 or 5-point harnesses and allows you to use the full potential of your high output machine. Don’t go through the hassle of cutting wires, all you have to do is unplug the old and install the new. No wiring or wire cutting required, simple plug & play installation. Required for use of any 4-point or 5-point harnesses restraints. Only 1 bypass is needed per vehicle. this plug and play override clips make this easy to bypass the safety sensor when the factory seat belt is removed (driver side). No cutting and splicing, just plug it in and ride on!
Krysten
2025-09-03 17:33:36
works great!
G. Greene
2025-08-13 21:30:49
Quick and easy install. In 5 minutes the job was done - no more seat belt light, no more hobbled performance.
Customer
2025-07-12 11:40:32
Works great. Fast delivery!!
DJ
2025-07-07 15:34:56
Easy hookup no more 11 mph sputtering. Would recommend
frank ebner
2025-07-03 10:59:21
Arrived and I took it out of the package and said " I'm a man and don't need directions " WRONG. Started a return and then watched a you tube video. Guy on video said it should take less then 5 mins. 2:39.Seems to work fine. No seat belt light and did over 15 mph
William S Collier
2025-05-30 20:30:11
This is easy to install once you find a YouTube video explaining where the connection is on the side by side. Also seems a little over priced for what is basically a plug with a jumper wire.
Jason Robinson
2025-05-18 12:34:59
Don't know what else to say. This does exactly what its designed to do, and you just plug it in to wire harness.
Nikolas Shay
2025-03-16 16:31:04
I watched the Youtube video from Russ989 from Hondasxs.com as it seemed to be the only video on how to install this on the Pioneer 1000. In his video the plug is located underneath the drivers side. I located what i thought was the right plug and it seemed to not work. Mine was slightly different. I had to take the clips out for the middle section of the bench seat in order to find the correct plug. I think that some of the reviewers who claimed it didnt work may have connected it to the wrong plug. Hope this helps
andrew linney
2025-03-08 16:11:53
Easy to install and does the job.
Becks357
2025-02-14 17:25:39
easy install on my 700 Pioneer.
Customer
2025-02-08 14:16:10
Upon getting in and out of side by side this wire allows to not have seat belt on
Recommended Products
