Shopping Cart

Your cart is empty.

Your cart is empty.

Shaft Coupler Connector L25 x D14 6mm to 6mm Bore Rigid Coupling Motor Shaft Joint Connector with Screw for 3D Printers 4PCS

4.9 (3) Write Review
Free shipping on orders over $29.99

$9.98

$ 4 .99 $4.99

In Stock

1.Size:6mm To 6mm


2.NumberofItems:4


About this item

  • Widely used in blowers,3D printer,DIY robots,CNC machine,stepper motors,etc. Similar to rigid clamp couplings, shaft couplers are used to hold bearings and sprockets tightly on the shaft, and are used in motor and gearbox assemblies.
  • Top tight type rigid coupling with screws to hold the shaft tightly; high torque with rigidity, low inertia and excellent sensitivity.
  • Single piece set screw clamp design makes it easy to set up the items on the shaft and control the holding capacity of the coupling.
  • Package Include: 4pcs 6mm to 6mm bore rigid coupling, 1pcs M4 Hex Wrench, 16pcs fastening screws.
  • NOTE: The rigid type basically does not allow eccentricity, and it must be fully adjusted during use.


Product Description

Shaft Coupler Connector Bore Rigid Coupling
Shaft Coupler Connector Bore Rigid Coupling

William Verstelle
2025-03-03 14:32:43
These are very well made couplers, they fit my 6mm shafts perfectly. They are finished with a nice blue anodization all over. The set screws fit well and it give a really nice look to your projects. These are top quality couplers.
Flash
2024-12-16 13:46:08
The machining is questionable. It is well over 10mm inside diameter by at least .005". The chamfer on some of the couplers are comically off center. So if you aren't looking for precisely made parts this will work. I was able to use shim stock to get it to work for now for me. Won't be getting again though.
rkruz
2024-12-05 10:52:15
The media could not be loaded.