Your cart is empty.
Your cart is empty.Robert D. Brust
2025-08-19 13:14:27
Well made, fit the purpose well. Deliverd on time.
Customer
2025-08-14 16:36:07
Works as directed
GSD
2025-06-26 15:32:14
Works for diamond hole saw. Works as advertised.
Gean Espitia
2025-05-21 11:13:22
Es un complemento para sitios donde no se puede usar la pulidora, ademas de ser mas facil de manejar ya que require menos fuerza en un taladro; esta hecho de un material resistente.
Todd
2025-05-04 17:14:13
Fit's fine, but the slightest tweak of pressure will bend this out of straight causing anything you attach to it to wobble like made. Mine bent within the first 2 minute of use. And ended up going staight into the recycle bin. Don't waste your money!
Samuel M.
2025-04-07 12:00:03
Sometimes "stainless steel" on amazon is actually very bad steel covered in a very thin coat of zinc (galvanized steel). The arbors/adapters I received were *NOT* galvanized. Seems like good steel. I had a wire brush wheel made to use with an angle grinder. I wanted to use the brush wheel with an electric drill instead. This adapter screwed in just fine.
Five0retired
2025-03-16 11:14:03
I ordered this SHDIATOOL Adapter for Core Bits Conversion 5/8-Inch-11 to 3/8-Inch Hex Shank, for a bathroom project. I needed a hex shank for one of my porcelain core bits, I am using on my drill. The hex shank, in my opinion, could be a little bit longer, and I am not too crazy about the round base, I think a nut like base would be better, just for something to grab onto, and tighten the core bit into place.
Michelle Sheahan
2025-03-12 10:29:12
The first purchase was for a 5/8-11 tri shaft and this would not fit in an extended. I needed to find, buy and use a hex shaft to fit my adapter. Drilled through 18 inches of brick with no issues. Worked like a charm
Casey
2025-02-19 12:13:58
Worked as described without failure. Used with a Vevor 4.25†x 14†diamond hole saw bit to drill through 7.5†of concrete foundation for a dryer termination.
gp
2024-12-26 12:15:14
c'est correct
DanQc
2024-12-24 10:22:55
screwed right on, no tread issues with mine, backing plate fits snugly, Good Quality. did not cause imbalance on my rotary tool, even with extra extension added.
Recommended Products
