Your cart is empty.
Your cart is empty.DarthRad
2025-06-18 17:44:57
I have four of the Sightmark laser boresights - the 12 gauge, 9mm, 7.62x39mm, and .223.I had used a Bushnell laser boresight before getting this set of chamber loaded laser boresights. The Bushnell is the kind that you stick into the muzzle end of the gun, fitted with an arbor matched to the barrel size. The problem with this device was that the arbors never fit quite right - they were always either too tight or too loose, plus you had to try to seat the body of the boresight in the center of the opening of the barrel (or muzzle brake) in order to properly align the center axis of the boresight with the center axis of the barrel. This rarely if ever happened just right as the slightest tilt in the seating of this boresight in the barrel would take it off the center axis so that rotating the laser would cause the laser light to mark out a small circle that was several MOA in diameter rather than being dead centered. Ugh.Of course with these chamber loaded laser boresights, there is also the potential for the lasers to be mis-aligned off the center axis. Plus there is the potential for the boresight to not fit the chamber properly. The key is to find a brand that has a measure of quality control so that you aren't stuck with these problems.I read through a lot of reviews before deciding on Sightmark. It is definitely not the cheapest out there. There are so many different brands and generic versions of these chamber loaded laser boresights now that almost look alike, with many much cheaper than the Sightmark. However, it was clear from reading the reviews that as the prices went down, so did the quality control. Several of these cheaper brands came with complaints that the lasers were not aligned to the center axis (resulting in the laser painting a circle as it rotates in the chamber) or that they did not fit properly in the chambers and so would either get stuck or wiggle.I have this theory that the really cheap laser boresights must be factory seconds or some such.I considered the Osprey line with the adjustable arbors, which saves money by allowing you to use one laser bore sight for different calibers. But, the reviews indicated that hassling with arbors would have an effect on accuracy and reliability.I almost got the Firefield, which seemed to have a similar number of decent reviews. Ultimately I decided against it because the entire line is made of an aluminum shell, and I think the brass shell of the Sightmark will hold up better.It should be noted, however, that the 12 gauge Sitemark is made out of aluminum, unlike the others, and is only painted a brass color.The biggest complaint against all of these laser boresighters are the frequent DOA batteries and poor battery life. The Sightmarks all come with alkaline button cell batteries. The small caliber ones (9mm, 7.62mm, .223) come with two AG5 batteries while the 12 gauge came with three AG13 (LR44) batteries.To get you all confused, the printed information on the back of the packaging for the 7.62mm and .223 says you can use 3 AG3 batteries in place of the 2 AG5 batteries (since the AG3 is a thinner battery with the same 7.9mm diameter), while the printed info for the 12 gauge says you can use 2 AG5 or 3 AG13 batteries. This is flat out incorrect since 2 AG5 batteries are too small to fit into the 12 gauge Sightmark battery chamber.Confused? Go to wikipedia and look up the article "List of battery sizes". Scroll down to the section titled "Silver oxide and alkaline cells". The table lists all the different names for each battery, their dimensions, and their mAh power rating. Note how the silver oxide batteries contain 1-1/2 to two times as much energy as the alkaline batteries.So the key is to go out and get some silver oxide button batteries, size SG5 for the AG5 powered Sightmarks and SG13 for the AG13 powered lasers. And don't go to your nearest retail store, since that will cost you an arm and a leg. Google shop for these batteries online. I found two Made in China "brands" one called Vinnic and another by Chung Pak Battery Works which were pretty cheap. The names aren't important, since I'm sure they will change rapidly. Just remember to get some silver oxide batteries online at the same time you are getting these Sightmark bore sights.How well did these Sightmarks work? The very first time I used one (the 7.62x39mm), I plugged in the included AG5 alkaline batteries and the resulting laser light was exceedingly weak. My initial reaction was that this was a bad laser. Then I remembered the silver oxide batteries I had gotten. When I switched out the batteries, the laser suddenly glowed brightly. Later, when this set of silver batteries finally wore down, the laser light faded again. That's a sign to change batteries.The larger AG13 alkaline batteries for the 12gauge shotgun boresight worked reasonably well and are still working as of this writing. Not surprising, since these batteries pack a lot more energy than the small AG5 batteries.As many have noted, the Sightmarks do not have an on-off switch. Once the batteries are screwed in the laser light is on! This is just as well, since the bore sights have to flush fit inside the chamber of the barrel and endure having the bolt and firing pin slammed into them. But you do have to have a plan of action ready so as to not run down your batteries. With one pair of SG5 silver oxide batteries, I was able to adjust the sights for about four guns, each taking about 5-10 minutes. So I am guesstimating a battery life of about 30 minutes with a fresh pair of SG5 silver batteries (the Sightmark packaging claims up to an hour of battery life - hah!).All of the Sightmarks have fit in well, none have gotten stuck (so far), and none have had off-center lasers.These chamber loaded Sightmark boresighters make it easy to dial in a scope, and for fixed sights, they help confirm the aim points. They are much better than the muzzle loaded bore sights, although the total cost is a lot more since they are ammo caliber specific.
A VERY private person
2025-06-11 16:51:45
CONSTRUCTION: The laser body is made of sturdy brass, nicely finished, and with an excellent fit for the firearm caliber. The version I purchased is for a .308 Win caliber rifle. The laser is perfectly aligned with the barrel axis, so it won't make fringes once it's manually placed in the chamber. If you follow the instructions that came with the laser you'll zero in your rifle in no time...and without spending a lot of rounds in the process. (A note to semi-auto firearm users, such as M1As: after manually inserting the sight laser into the chamber, do NOT slam the action as you would with a normal round - this will damage the laser. Instead, SLOWLY advance the action until it closes the breech. This note is in the user's manual, too, but it won't hurt to note it twice.)ACCESSORIES: The laser comes with a small holster for storage, made of ballistic nylon. The holster is large enough to store the laser, its batteries and the user's manual. {However, it is small enough to lose it, too. ;-) }. It comes with a set of two button-size batteries (LR 754).Some things to note:- it's not a high-intensity laser. Therefore, you may have difficulty seeing the laser beam at 25 yards in the open on a very sunny day.- due to its size, the laser uses two button batteries (LR 754), and those don't last a long time. My recommendation is to keep the batteries in the provided pouch until ready to use, and to carry a spare set just in case.CONCLUSION: For what it was designed, it does an excellent job. I wish the laser intensity would be higher, or be of a different wavelength (color; e.g. green) for better visibility in bright, sunny light. I will definitely buy it again if I lose or damage it (I hope I won't), provided the company is still there if that happens.
Troy
2025-06-10 15:51:14
Used this to get my red dot close and it worked perfectly. I used it in the evening so it was super bright but you can for sure use it during the day. Usage was easy
MAXIM LUBINSKI
2025-03-13 17:53:14
Great product. Good price. Recommend.
Sehnrather
2025-02-10 17:09:44
Gutes Hilfsmittel beim Ermitteln des Haltepunktes. Funktiniert nur bei Dunkelheit.
Trista Garnett
2025-01-29 18:58:22
This was perfect for setting my gun. Won't miss nothing this hunting season. The product was exactly as described in the item description. I live in Canada and the parcel arrived at my door in less than a week. I find that to be decent shipping speed. I would recommend this product to my friends and family. I would definitely buy again!
Claude St-Amour
2024-12-26 18:01:04
Lorsque nous savons comment nous servir de cet outil pour mettre à zéro notre Lunette de visée. J’en ai moi-même expérimenté son utilisation, et suivant la bonne méthode pour l’utiliser, j’en arrive à placer 3 balles en plein dans le mille une 300 mg. J’ai refait le test avec ma 270, et je suis très satisfait du résultat qui est assez similaire compte tenu des distances qui ne sont pas les mêmes pour ce que j’en fais de mes différentes carabines. Je recommande ce vendeur qui a été impeccable sur le traitement l’expédition et du colis.
Customer
2024-12-05 19:06:52
This is very bright. It surprised me. All of these brands would benefit from an on/off switch at the back of the unit, but it doesn’t take away from the functionality at all. Nice little carry case for it. I removed the batteries and placed them into a very small ziplock bag and then put them into the ‘pocket’ within the nice case.
Recommended Products